Search:

Do you still have this.

Some parts stores have them

You can take it apart and take the piston out. There is an oring on it that will be worn or just hard from age.

Change the whole side cover

Go back to stock jets to start from. There is alot more to fuel curve than just the jets. Air bleeds. Power valves. Etc

5 to 6 lbs on gas should work fine

Ok bullet agrees that cam has abnormal wear on the rear lobes. They are sending new cam for 25 dollars so hopefully no more problems.

The z 28 spring 130 lbs closed pressure 1.5 ratio. Bullet will get it today and hopefully they find something wrong with it.

Just one lobe but some very abnormal wear on about 4 others

I called bullet today and they had me send cam and lifters to them. Hopefully they will find something. This is a single 1.25 valve spring. Basically the z28 springs. That is the odd part is they...

Is anyone out there having any problems with bullet flat tappet cams going flat within first 10 minutes. I know all about good oil and zinc additive. Several of the lobes have a very odd wear...

They do help with power if placed in the right spot. Have to play with the position to find what it likes the best. As far as it being classified as a muffler depends on who you ask and what the...

If it looks like brand new metal it's probably been decked

Goodson tools

I agree after awhile you just ignore everything stocky has to say. The sad part is that he probably does have some useful information for some people and could help but his sarcastic smart mouth just...

I second everything he says about your sarcastic comments and try to make everyone seem stupid compared to you. I am really glad others see you the same way.

This is the carb spacer that has the two steel plates on each side of a rubber center to eliminate the vibration into the carb. It is 1 inch thick and like brand new. They sell for 150 ish if I...

No its your smart*** answers like always. I never changed the oil since I run atf not oil. That's all you are ever good for.

Ok you win.

I will have to say you didn't run 50 to 80 nights on a direct drive without changing oil or clutches.

Direct drive powerglide. What is everyone using for trans fluid. Obviously with direct drive the input shaft is turning the entire time the motor is running so the direct clutches are going to see...

Input on running stock vs aftermarket input shaft on a powerglide. 2 barrel imca stock car

Anyone built their own self bleed valve body for a powerglide that is direct drive with no foot pedal or ball valve. I know they are putting a jet or bleed hole in valve body to release the pressure...

They do work real well but take a ton of work. Check local rules to see if they are legal. From the outside its almost impossible to tell what it is.

How about anyone using the pontiac nose on the 99 monte body