Search:

Yep, I have the same spec. So what's the procedure to get to that spec.?

I backed off the springs last fall to relieve the tension. What's the proper way to set my lash now?

Looking for a set of Bob Harris set up DVD's. Let me know how much to be shipped. Looking for a used set. Thanks.

Looking for a good used set of Ruggles scales or something similar. Located in S. MI willing to travel or pay shipping. Let me know what you have.
Pics help.
mcnicol25@yahoo.com

WHAT ARE SOME GOOD CARS UNDER THESE RULES?

15.1 – Engine
A.) Only three (3) or four (4) cylinder in-line engines will be permitted.
B.) All engine components must remain unaltered and OEM for...

Yep usually somewhere in the 70's is what I get out of the Meijer pump here in MI. For the most part it will run just fine on that. If the hesitation gets to bad off idle I'll go get a gallon fuel...

I have run E85 with very few issues for the past 3 years. At the start of this season I had a very similar problem. I went .040 air bleeds on the outer four corners, cleaned the metering blocks,...

Fixed it!

Removed the metering blocks, cleaned everything up real good, sprayed out all the passage ways, installed different size air bleeds, drained the fuel tank, installed fresh fuel, fired...

Lowest RPM it will run at is in the 1800-2000 range. It won't idle no matter where I put the mixture screws.

Fresh 358cid, SBC, on E85. Holley 4150 Prosystems carb. Have had this setup for about 3 years now. It's always been a little touchy at idle, but this season I can't get it to idle at all. It will...

I have a camaro front sub on my car currently with all camaro front end parts. I need to replace the right front lower arm, bent, can I use a metric arm and if so, does it change anything in the...