Search:

What type of gains would be made by advancing the cam or retarding in a crate? Would it be noticeable difference on track?

Can a certified imca engine builder when installing cable locks touch the internals of the crate engine? Example- advance or retard the camshaft.

Just wondering if anyone have any info on them? Looking for some baseline info, measurements, and so on. Got a used car that is a converted northern sport mod and just looking for some info. Scale...

Thanks for the answer. Why doesn't the rule state that for the upper link. It only states center in the housing it says nothing about chassis mount just wondering.
Thanks for the answers

Most be some big secret. No answers

Rule.
Must use one upper control arm, solid tube only, located at top center of rear end housing and remain centered (one inch tolerance) on housing over drive shaft

Does the chassis mount have...

I enjoy these thread great learning, am going to go ahead and take the bait. We found by adding angle in the j bar when the track went dry and slick, it helped with side bite in on entry and middle,...

would you not want to adjust from heat to main where the track drys out and more roll is needed in the car to help gain rr traction?

Yeah i know what your talking about i got that spring in.

Did a basic rebuild for the first time. Went back together good but have one little spring left over and don't know where it goes. It's a cone shape spring I don't even see if on the exploded...

This is a few questions about 3 link suspension or similar suspension types. First static setting for LR link for a 3 link, is there a max degree to start with? is there something as to much static...

would it help load the rr more on late corner entry as you begining to pick of the thottle?

If you raise the rr bar up on the chassis and reset your static tail in the car, what changes would you feel off throttle going in and on throttle changes?

Ub products and keyser/port city has them

So they are the same? Where to order some?

Camaro clip car pro stock, need to order some spindles for spares. Question are intermediate spindles, impala spindles the same as camaro spindles, the clip is a 75 to 81 clip. Also where is a good...

To be honest we thought we had a stiffer right front in the car until we tested the spring when we put the car back together, and it turns out we have been running the with the lf stiffer then the...

Thanks for the reply so far please keep this going. By going softer rate would you need more shock to control that spring from bouncing. What would be the result of maybe bring the front splits...

If nothing else change and you left all your splits the same but drop 50lbs of rate in front spring and 25 lbs in the back what would be the effects felt.

Rf 900 to 850
Lf 1000 to 950
Lr 225 to...

Call isky cams and talk with a tech, best service in the business.

I know I agree with all of you I do. I believe we will change it soon but it was just one more expense right now of a high $$ bill. We figure when can change the intake out a little later on. Should...

A little update, got the motors together by the engine guy. BTW looking for a good engine shop person in southern california, we are sick and tired of the guy we are using. Went with a isky cam for...

Can anyone tell me how to plumb a expansion tank into the cooling system. We just order one from speedway and has no directions on what goes where. The a an fitting at the bottom of the tank and...

Thanks guys, yes I wish we could have a little better combo for the motor but this is what we have and trying to make the best out of it. With that we are on a 7800 rpm chip rule so I know we are...

Yes we run wuss rules. This cam is real close to what he recommends I believe. This is an isky camshaft. We have a real nice Wilson manifold tapered spacer already. What makes the super victor so...