Search:

intersested in a crank see my WTB post.

Looking for a stock Ford 2.3 crankshaft. One piece rear main preferable, large journal mains. Standard sizes on main and rod. email me if you have one that you want to sell. Thanks.

dave at...

Thank you very much.

engineczar what was the weight on the rod and piston separately? I'm thinking about this package also. TIA

@ Old Rob, wanna sell some?

TTT Still looking

Anyone??????

Looking to buy a set of four ford 2.3/2.5L 5.4" rods with casting (f5)

Just changed from a fully locked 8" rear to a trac-loc (clutch type) 8" rear.

When lifting for the turn does the trac-loc unlock? If so how do I get back the steering effect the fully locked rear...

Where in CA? I have a couple of 1.97's no shifter.

I can't use a header. I do own pipemax. Collector length of 38.1" on my set up. It's that the measuring starting point on the collector is iffy on a stock manifold, and measuring a bent piece of...

I believe that some cam bearings are grooved on the non bearing side (makes installation easier, no oiling holes to line up). So if the hole on top of #2 and #3 aren't plugged, then a loss of oil...

When tuning for tailpipe length for proper exhaust scavenging, is it possible to measure a intake manifold vacuum improvement? Also is the cast iron tri-yi manifold worth the hp/weight over the...