Search:

Type: Posts; User: billetbirdcage

Page 1 of 20 1 2 3 4

Search: Search took 7.75 seconds; generated 56 minute(s) ago.

  1. Replies
    20
    Views
    5,616

    Replied to PM

    Replied to PM
  2. Replies
    20
    Views
    5,616

    I have another way that should work way better...

    I have another way that should work way better and be really hard for tech to see or figure it out, but don't want to post here for everyone to see. If you're interested send me a PM.

    I don't log...
  3. Replies
    20
    Views
    5,616

    Try this so a restrictor doesn't keep the brake...

    Try this so a restrictor doesn't keep the brake on

    https://i.postimg.cc/wM9dPP1y/brake-bypass.png


    Red is the restrictor and blue is a one way valve to release pressure around the restrictor.
  4. So your saying after spending 850K on a new...

    So your saying after spending 850K on a new hauler, I need to spend more and get a 100 Ton AC unit and a 1,000,000 BTU heater for the trailer to complete????
  5. Replies
    9
    Views
    2,095

    A friend at one of the big companies saw this...

    A friend at one of the big companies saw this post and reached out to me thru a text since he isn't registered here.

    Here is what he had to say: "The ones we sell spark a lot until they get up to...
  6. Thread: E85

    by billetbirdcage
    Replies
    30
    Views
    6,797

    You won't see a power lose being to small on gap...

    You won't see a power lose being to small on gap but will for sure if too big.

    It hurts nothing to start small and see if it helps your issue. I have ran a magneto with .018 gap vs an MSD6 with...
  7. Replies
    59
    Views
    20,094

    Yes, for the most part. It does vary on what...

    Yes, for the most part. It does vary on what brand of motor your talking about or what style of motor.

    Last I knew a new chevy from Clemens is 55K
  8. Replies
    59
    Views
    20,094

    A shock that was deemed illegal years and years...

    A shock that was deemed illegal years and years ago, but bilstein made the shock where basically it had a cover on the top of it so the shaft didn't get exposed out the top of the shock that a "thru...
  9. Thread: E85

    by billetbirdcage
    Replies
    30
    Views
    6,797

    This may go along the lines to back up some of...

    This may go along the lines to back up some of lizardracings info:

    The improvement I think we saw on both motors (wasn't scientific by any means) when I swapped boxes also included the coil change...
  10. Thread: E85

    by billetbirdcage
    Replies
    30
    Views
    6,797

    Not sure what your running for plug gap, but you...

    Not sure what your running for plug gap, but you can kill 50HP and a ton of RPM out of a motor with too large for your ignition and never hear it on the dyno or track. You might try closing it down...
  11. Thread: E85

    by billetbirdcage
    Replies
    30
    Views
    6,797

    While it's not E85 but on gas engines. One a...

    While it's not E85 but on gas engines.

    One a smaller spec type engine (700HP) Builder said 8800 but in the car it seems to stop at 8200/8300. Did same thing you did add some gear and still turned...
  12. Thread: E85

    by billetbirdcage
    Replies
    30
    Views
    6,797

    Can't say I've experienced that with e85 but...

    Can't say I've experienced that with e85 but haven't ran E85 on a lot of dirt track stuff besides a crate which doesn't get to those RPM's.

    I'm gonna say it would more likely be Fuel volume issue...
  13. Replies
    11
    Views
    3,067

    I'm gonna go out on a limb and take some educated...

    I'm gonna go out on a limb and take some educated guesses here, so. . .

    I would say most of the people that would have one, wouldn't run a tire long enough to get into much of a sidewall stiffness...
  14. Replies
    11
    Views
    3,067

    Some of how much use you would get out of...

    Some of how much use you would get out of something like that is:

    1. If the spring rate is way off what you normally get with the tires you run, can you just go out and buy another tire without a...
  15. Replies
    14
    Views
    5,284

    Surely with front stagger, since the LF is...

    Surely with front stagger, since the LF is turning faster then the RF: The car will drive right, correct? (sarcasm)
  16. Replies
    5
    Views
    1,832

    Agreed. On a side note, with higher pressures...

    Agreed. On a side note, with higher pressures make sure your hose connections have a good bulge or ridge on the component or you can blow a hose off.
  17. Thread: Pierce

    by billetbirdcage
    Replies
    35
    Views
    13,958

    When it was built, it was the largest Dirt LM...

    When it was built, it was the largest Dirt LM engine that Cornette had ever built, is that still the case? not sure. It's a couple years old now, if its still the same one Kevin had before.
  18. Replies
    3
    Views
    1,320

    aluminum or carbon fiber sheet

    aluminum or carbon fiber sheet
  19. Replies
    8
    Views
    3,876

    Sometimes you are using them for a reason, like...

    Sometimes you are using them for a reason, like using a softer spring but making it stiffer to the rate you want at a certain compressed measurement but wanting more preload in the spring when...
  20. Replies
    8
    Views
    3,876

    Example 300# spring 1" is 300# 2" is 600# and 3"...

    Example 300# spring 1" is 300# 2" is 600# and 3" is 900#

    could always go to a 325# spring: So 1" is 325# and 2" is 650# and 3" is 975#

    Taking liberties here on the rubber and how much it...
  21. Replies
    8
    Views
    3,876

    A spring rubber basically makes a spring...

    A spring rubber basically makes a spring progressive. It progressively deactivates one coil of the spring so the rate of the spring increases the more that one coil is being inactive by the spring...
  22. Replies
    2
    Views
    1,341

    It depends on what kind of heat your seeing out...

    It depends on what kind of heat your seeing out of rotors by how hard you are using them. That being said:

    If your a crate or limited and not using a ton of rear brake, then a normal rotor will...
  23. Replies
    35
    Views
    7,901

    For sure, I'm being very generous with how little...

    For sure, I'm being very generous with how little it could cost to run a tour. Did I just say how little super engines can cost, LOL
  24. Replies
    35
    Views
    7,901

    Also keep in mind that just the engine builders...

    Also keep in mind that just the engine builders bill on engines. Lets say guys run 400 laps on oil so only 3 oil changes per engine before freshening. Oil is 250.00 or more depending on what your...
  25. Replies
    35
    Views
    7,901

    Every team is gonna be different on how many...

    Every team is gonna be different on how many complete spare cars they have and extra engines. Take lucas oil for example: their lap count varies a ton per event with features as short as 25 lap...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4

All times are GMT -5. The time now is 06:09 PM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.