Search:

Hi,I realize this is an old thread but I'd like to know the pin height above the bottom of the lower ball joint hole. Thanks, Dan

Exactly what I was looking for................Thanks for the links..............Dan

I can't find where GM lists the specs of their crate engine internals................Can someone direct me to a website please?.............Thanks,Dan

I went looking and found this picture but on a site with Asian text, can't read what they are saying about it.............Dan

they do...........I'm not going to buy a crate because I prefer to build my own engines,,,................Just trying to get a feel for how exotic I need to be in parts selection for a 2-barrel iron...

Also, my rules say crates must run a 6600 RPM chip..........................Would a 602 hold up running up to 6600 every lap?....................Thanks,Dan

That's what I have in mind......................... If it's...

thanks for getting back..........By "steel" do you mean forged?...............Thanks,,Dan

Hi,............do the 602 and 604 grate motors use cast cranks?.................Pressed metal rods?....................non-forged pistons?...................Thanks,Dan

You're right. Direct to the pump, no rear pump................Instructions I got on adjusting the low gear band was to torque it to 70 ft.lbs., then back off 4 turns.................I'm thinking if I...

Anybody know about powerglides?.....I want to make a push start mechanism for my powerglide but not hydraulic, i want something manual......I think I can use parts from a motorcycle clutch release...

Hi, I'll be building an LT1 circle track motor soon and am new to Tucson so am asking for recomendations as to a good race engine oriented machine shop in Tucson. Feel free to pm me at...

How the heck do I shape a post to have paragraphs?I type it in several paragraphs but it publishes as a string.Dan

Guess not.Can anyone suggest a forum that is focused on asphalt modified chassis setup?Thanks,Dan

Hi,Someone here might be able to help me.I was following an asphalt modified forum at the RacingWest.com site and the whole website dis-appeared.Anyone know where it went?Thanks, Dan

I'm going to set it up for 2" offset and elongate the mounting brackets so I can move it a little either way if I want to later.Thanks to all,Dan

Just spent some time with the new rules, the only engine location rule I can find is 6' forward of the rear axle. I'll see if I can get ahold of Chas Howe for starters.Thanks,Dan

Hi,New guy here, building an asphalt modified and have no experience with them. Depending on engine, the rules state between 56% and 58% left weight. How much, if any, of the weight offset needs to...