Search:
Type: Posts; User: Havoc5
Search:
Search took 0.76 seconds.
-
On our mod were running a 400 lf 450 rf 100 lr and 225 rr. Car is tight from the start of the night until the end. Isn't bad once it slicks up but could be a touch looser on entry still. I was...
-
Krom any recommendations or area you like to stay in angle wise? I've been doing some trial and error and this next week out was going to raise the right upper more
-
Couldn't you have a higher static load and achieve the same drive from a 400 spring as you can with a 600? Referring to the right front spring.
-
In that sense couldn't you tie the corner down harder with rebound to keep it from coming off
-
Is there a point where a softer spring should end up creating more drive? Assuming it allows the car to get into the bump harder? My thinking is the bump would gain rate quickly which would tighten...
-
Race engineer- it won't allow me to quote but relating to your response how would it be any different from running a coil bind set up? Wouldn't the two work fairly similar but the bump obviously...
-
I agree it isn't much material but essentially shouldn't it work the same? According to the indicator we were on the bump but I guess my question is can you create more drive with rebound in the...
-
I'm new to using these and the series I run basically only allow a 1/2 inch rubber. To clarify this is a modified are running but I thought I'd get better answers here. We went to a 400lb rf spring...
All times are GMT -5. The time now is 09:21 PM.