|
|
Search:
Type: Posts; User: ncracer1st
Search:
Search took 0.72 seconds.
-
What header are best on 602? 1 3/4 or 1 5/8-13/4 stepped, 3 inch or 3 1/2 collector?
-
I knowI spent $220 on new brinn couple and it was the same one I had.
-
I figured it out, I had a cheap no name starter and the gear is to long. Works on winters bellhousing maybe burt bellhousing. Brinn website says .860from mounting surface to end of gear, my starter...
-
Thanks I will check that.
-
I have brinn crate flywheel no balance plate and have mid plate.
-
Its as all brinn. Brinn trans, brinn flywheel, brinn bellhousing and brinn idler.
-
I bought a brinn bellhousing and when bolting the starter on the idler gear pushes in to far and engages into the flywheel about 1/8 inch, what do I have wrong?
-
What pitman are should I use with metric chassis with older style box?
-
-
What are the ride heights with s7 spindles?
-
I have an 03 or 04 bms and need some setup help. Tried calling bms and didnt get answer even emailed with no responce. Metric clip metric lowers pinto spindles 9" rear end came with rubber bushing...
-
I have a stealth 650 forsale.
-
Is brinn still forsale and where are you located?
-
-
ha ha i said performance wise!
-
Is there any differance performance wise between a 4inch and 5inch air filter?
-
I measured my smackdown car to night so I can order a new drive shaft. With an original brinn trans and standard length bars the tail shaft of trans to yoke on rearend measured 39 1/8. So that tells...
-
How are you messuring drive shaft to get 39inches?
-
What length of drive shaft does a mastersbilt with a brinn transmission use?
-
-
-
-
looking for 2010 or newer mastersbilt smackdown chassis. I have all the parts ,just need chassis c0ckpit, deck brake lines.
-
-
Thanks TALON75 thats the kind of answer I was looking for.
All times are GMT -5. The time now is 06:08 PM.
|
|