|
|
Search:
Type: Posts; User: ToddSmith16
Search:
Search took 1.43 seconds; generated 31 minute(s) ago.
-
Check your travel ensuring your not bottoming shock out.
-
So right..........a crutch..easier way to get the car to turn rather than figuring out total handling!
-
Best bang with 2bbl motors is high compression (13.5-14 range), worked heads nothing over 215's, 2925 or the 2V, 2bbl cam, LW crank/rods and perfconn is correct 7200-7400 and nothing more as there's...
-
I say go with a gremlin body!
-
then you're looking for a Layne transmission
-
May not need to buy anything. What are the front spring rates? What are your %'s? Do you have brake bias?
-
-
Pinion angle on a stock 4 link doesn't matter.
-
Throttle turn it....no brakes as it kills your momentum!
-
-
-
Cutt the pillars near the front fenders.
-
Those are real donor cars. The wheel base for the 95-99 Monte Carlos matches up to the chassis. If you should go that route keep the rear speaker platform in the car for stability. Cutt the top off...
-
single or double pass radiator, no restrictor, 1:1 pulleys, 4 blade fan with a good shroud with the blades half in on/out the shroud should fix your problems. Also check your plugs to ensure your not...
-
I'll have to agree on the bent axle as being the problem.
-
That combo does work! I ran 436 with 14.2 to 1 on a 4412.
-
if ya can't figure out how to turn a tight car then I would question the person in the seat....find a sub...LOL!
-
rf 1000, lf 900-850, lr 275 and rr 200-225...........this will get you in the ball park then fine tune it with spring rates, shock valving and air pressures.
-
Throttle turn it if there's that much bite in the track!
-
-
Its been set back if #1 plug is in line with the ball joint.
-
Great car! Craftmanship is top notch. Customer service not so much. Buy a straight used chassis versus new! If you get one, get a hold of me and I can help ya with it.
-
You have to much rear and left % in it. Get left and rear down to 54-55% range. I ran with 216lbs of bite with a 53% cross.
-
First off, a 4.11 with a 1.82 ratio tranny gives you a final drive of 7.48. Let the RPM's soar! A 6.66 gear is what we run on 1/4 mile tracks. I would have a gear in the 6.0-6.33 range depending on...
-
15 in LF and usually around 12-13 in LR...LR is going to depend on what you want your stagger at. I used 26.5 all the way around. Didn't like the feel of the extra sidewalls with 27.5. Make sure your...
All times are GMT -5. The time now is 01:26 AM.
|
|