Search:
Type: Posts; User: outlaw087
Search:
Search took 0.13 seconds.
-
is square port headers square looking. my headers has straight sides, top and bottom , but the corners are rounded and the corners come inside the port just a little bit. the heads are alum. 190cc ,...
-
I have a set of speed flow 1 5/8 headers that are oval port and my heads is square port. Will these headers work?
-
I was talking about the top arms. I have my lowers level. all of my mounts is adjustable and on tubs and rod ends. all of the mounts is in the stock location.
-
if u r on the gas when rear end rotates the bars ( angles down ) pulls up on frame taking weight off the rear end. if the bars ( angles up ) pulling down on the frame it keeps wight / bite in. does...
-
I agree with stock car driver. I think that top arms is angles down when on the gas it pulls up on the frame and takes bite out and the arms up it pulls down on the frame and keeps bite in. is this...
-
Ok i will call KMJ Performance or pro comp THANKS FOR THE HELP ON THIS.
-
what would i torque the pro comp I beam rods to with 8740 3/8 cap screw bolts if i do not have a gauge. i have never used these kinds of rods with the bolts be for. we build all of my motors and has...
-
the last motor we built had 041 ( 194/150 ) 64cc heads with speed pro .100 dome pistons and .537 / .555 cam. is the pro star alum. heads with 64cc 190 intake runners 202 / 160 , and speed pro .125...
-
ok thanks things have changed in the motor building over the years. the last motor we built was in 2003 and we just did it the old school way, but the new rods and bolts are different now i reckon lol
-
I did not know that they use stretch now instead of torque. we always used GM pink or x rods in my motors and torque them to 45 ft/lb. these rod is pro comp bushed has 8740 3/8 cap screw bolts and...
-
what do u torque sbc I beam rods to with 3/8 cap screw bolts
-
-
Is ProComp 190cc aluminum cylinder head better head than the 041 heads. I just want to up grade from the 041 to a better head . I just want a good head for reasonable cost +/- $ 600.00 Going on a...
-
I run a 8'' tire on a 10'' wheel ( D30 Hoosier ) with no problems at all.
All times are GMT -5. The time now is 06:03 PM.