Search:
Type: Posts; User: toloud
Search:
Search took 0.32 seconds.
-
Flat tire under caution while leading.
-
mother nature wins another
-
There are spacers made to go between the caliper pistons and pads so you can even use the calipers you have. I don't know who makes them but the ones we had came from rocket.
-
Dave runs the morgantown WV melvins automatic transmissions 304-296-2091
-
I am not sure when the last raise was but your car will have it.
-
Since Wilmoth was a no show at Duck river and they are in the process of scrapping the Bloomer ca r experiment and looking at chassis options that they are probably off the WOO tour.
-
Scale position for top rods is in the bottom holes . From the looks of the bottom brackets scale position for the bottom is either 2 or 3 up from the bottom. Call rocket to make sure. The reason to...
-
This could have started as a combo car a few bolt on brackets to add or remove and you could run swingarm. Lb bar 15" Lt bar 18.25" Lt short bar 16.75" The newer Lt shortener bracket
does not...
-
Jared Hawkins will not be there his brother Jacob is getting married that weekend.
-
Brinn says .040" to .070" between idler and flywheel. The information is in the tech section of the brinn website .
-
rocket makes a drop shock mount that bolts to both sets of top holes. this mount drops the top shock mount 1 3/4 in. have only seen this ran once.
-
Swift makes a 16" 125 barrel spring some rocket guys are using.
-
Yes you can use the same rack with the same ends. I did not measure the spacer between the rack and frame but it looked 1/8. RF needs the small spacer that comes with a sweet rack at the rack nothing...
-
Get a 1" wheel spacer. A lot of newer rockets come with the shorter tube and a spacer.
-
One other thing to consider is firing order. A lot of damage can be done with wrong firing order tri -y headers.
-
Depending on your car there may be good reasons a one piece is better. On our blue front rockets the lower spring mount hole is an inch lower to keep the shock from bottoming out. On these cars when...
-
There are some rocket guys running these numbers. We have had some pretty good success with 900 to 1000 @1" per sec.
-
On our 2011 rocket we use a cable on the rr set to just before the shock tops out as protection for the shock. You will find it aids greatly in holding the rear in place during changes. Also be...
All times are GMT -5. The time now is 07:13 AM.