Search:

Type: Posts; User: 44xForever

Search: Search took 0.58 seconds.

  1. Can you use this with a drop or bent outer...

    Can you use this with a drop or bent outer instead of a straight outer rod?
  2. Good to know. Thanks for that too.....this car...

    Good to know. Thanks for that too.....this car was ran in IMCA in Maquoketa, it had the stud set up, but I was fairly certain that wasn't legal most places. I will look for the extreme clearance set...
  3. Would you happen to know if you can use the 5/8...

    Would you happen to know if you can use the 5/8 stud mounts and heims on the center link for the inner tie rods instead of regular inner tie rods?
  4. TS3g Thank you for the info! much appreciated. I...

    TS3g Thank you for the info! much appreciated. I will have to check the spindle on the right front, the original ball joint that was in it had a .300 spacer under the spindle the ball joint went...
  5. Chevelle stub 3 pc spindle ball joint question

    Does anyone know what ball joint is needed for stock chevelle lower control arms with allstar 55970 and 55971 3pc pinto spindles? they say they use stock metric ball joints but I don't have metric...
Results 1 to 5 of 5

All times are GMT -5. The time now is 04:38 PM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.