Search:

Ttt---------------------------------------------------

Ttt------------------------------------------------

around a 6.40 or so

Car and trailer sold

also comes with scales, front end gage, toe plates and spare new front and back bumpers

2008 smackdown, outpace 4 bars, tie rods and 1 piece lowers. Top a-frames are howe roller bearings with low friction ball joints. 12 nite old from new race 1 604, JDR e-85 carb, 5/8" HVH spacer,...

2008 is the same lenght

sold months ago, was a friends car, I'm on Integra IDA's

longer right lower a-frame, different rf upper, longer tie rod tubes, lf is the same, also ride heights are 3.5 inches. can get you the specs as I went to Mstersbilt seminar, just pm me and I will...

will sell for 1500.00, need it gone

SOLD motor had new rings and bearings last year, ran 18 nites. needs valve springs, sealed and a few heli coils on left side head for header bolts. 1800.00 Send PM to me and I will reply. older...

Transmission doesn't matter Just be sure if you have a brinn bellhousing use a brinn flywheel, or a bert bellhousing use a bert flywheel. Bert flywheel is a little smaller, will work in a brinn...

Bill, Craig had one down at allen automotive

What hole do you have your right lower bar in? That has alot of input on entry. Lower, tighter, higher frees it up

Crate late model team sellout. 08 smackdown car, 604 crate motor with Stealth lightweight E-85 carb, Genesis double adjustable gas shocks from Mastersbilt, new this year wirh ohlin 5th arm shock....

SOLD Crate late model team sellout. 08 smackdown car, 604 crate motor with Stealth lightweight E-85 carb, Genesis double adjustable gas shocks from Mastersbilt, new this year wirh ohlin 5th arm...

Make sure you have a good ground, to check use a set of jumper cables and run from the negative on the battery to the engine block, bad grounds can do that

Where are you located, I"m in Peoria

How long is the driveshaft?

I have 2 7" beadlocks 100 each

when we put the seal in I use the top part of the old cheap jack stand. The open round end fits the seal almost perfect and the flat stand piece I hit with a hammer to drive the seal in. The extra...

thats right

I have 2 7" bead locks, would sell for 120 a piece or trade them for good non beadlock 14" wide 5" offset wheels. These are 14" wide wheels.

I"ve bought several things also, allows in the shape he says, good prices and ships it quick!

races canceled for tonite, races still on for Sunday at regular time