|
|
Search:
Type: Posts; User: biggy72
Search:
Search took 0.49 seconds.
-
I drilled a hole in the lid of a Gatorade bottle and used gasketmaker to seal a hose from the vent on the rear end into the bottle. I zip tied the bottle upside down above the rear end with plenty of...
-
Sorry I was wrong, the escort flywheel bolts work in the mustang crank.
-
A little late, but just get the automatic transmission flex plate bolts.
-
I picked one up this past weekend at our local racecar supply shop. He was only asking $130 for the two halves. I was worried about how much shipping would be and was surprised by the local guy's...
-
I found a cast mount off of an old courier, but I'd like to build something significantly lighter too.
-
Is the clip on the main shaft against the rear wall of the transmission? Does it come out with a magnet or something? There's not must room behind the last row of gears.
-
Norton22,
I am trying to swap my tail shafts right now, but I can't figure out how to get the tail shaft off of the transmission. Any advice? Also it looks like the shift rod end has the same...
-
I don't know yet. The new radiator's on it's way. I went looking through the junk yard this last weekend and all I could find were what looked to be single row radiators, but my old one was a dual...
-
I just ordered an aluminum racing radiator from Speedway motors for around 115. You can order whatever width you need.
-
If it's only one corner it could be a collapsed brake line.
-
Is there a premade water neck with a fitting already built into it, or do you just need to get a steel female fitting and weld it in?
-
I tried posting a link, but the admins don't seem to ever get around to approving links. Anyway use wayback machine to look up the breezeman archive
...
-
I need ratios for a 77et 7006aa and for a 74wt 7006 aa. I know they are a 2.14 mustang and a 1.97 pinto 2nd gear, but I'd like to find out what third gear is for either trans too.
-
I can't seem to find a manual fox body mustang pedal set at any of the junkyards around here. Anyone have a set? I could use the brake and clutch assembly and the gas pedal assembly but I can find...
-
The other guys might have you covered, but I have both of the gear sets you're looking for. Not sure where you're at, but I'm in Washington if you're trying to figure out shipping.
-
I tried posting a link yesterday, but I think it's waiting for moderator approval. Anyway go look at the AR Bodies facebook page and they have some pictures of the nose on there.
-
Just an FYI, they are going to be building a 2300 on Horsepower TV this weekend on Spike. From their website it looks like Esslinger must be paying for it because the thing is chock full of Esslinger...
All times are GMT -5. The time now is 11:36 PM.
|
|