|
|
Search:
Type: Posts; User: raceinmud
Search:
Search took 1.38 seconds.
-
Anyone know where to find a race cam that will pull 14 lbs? Thanks!Ok, I have looked at all the companies that I could find and cams are sold by lift. Was hoping a fellow racer could point me in the...
-
Locked out my sons 2.3 duraspark set it at 36, rev engine timing retards 5 to 6 degrees. How can I fix? Can't just run out and buy something. Need to try and make this work. Thanks. Leon
-
Anyone have an alternative for the 1/2 20 wheels studs for a pinto instead of the ARP 5 for 76.00? Thanks, Leon
-
Picked up a RAD B -1 trans and have searched for info. So far 1974 Mustang II 10 spline. Any help on info of things I need to put in Pinto would be greatly appreciated. Thanks, Leon
-
Anyone run their pinto with an auto? First practice with car and lost all gears? Tough out here in colorado to locate a 2.14 4 speed setup. Just wandering if any had good success with the...
-
Ran at Calhan the first year it opened in my stock car. My son is running his pinto in Lamar
-
Thanks everyone. Ended up using cable, cut/moded oem bracket and it worked. Twisted end of race pedal and ran the cable to it. First practice this weekend, will see how it goes. Thanks, Leon
-
Trying to figure out throttle linkage for pinto with Holley carb. Have racing peddle pics would help Thanks. Leon
-
Did a search with no luck. Need a starting point for wheels on my son's pinto mini stock on dirt. I was thinking 3of on the fronts and LR and a 4of on the RR? But not sure they will clear or be...
-
2.3 ford, do I need to run the alternatorThanks Leon
-
Anyone have a drawing to wire a 1977 pinto 2.3. All the wiring was removed from car, don't know where to start. This car is a mini stock. Thanks, Leon
-
Well, I'm going to try to make a chevy intake valve (1.94 and valve stem same diameter as ford valve ) into a cutter and and try and cut pistons in the block. They are the H435p pistions, so if i...
-
Anyone have good luck cutting pistons for larger valves?Thanks
-
Does anyone know where to find .020 pistons cut for large valves?Thanks, Leon
-
Does the pick up for the front sump type pan need more of the screen area opened up over the stock opening?Thanks, Leon
-
Can I get some pics of how the fuel cell is/was mounted. Thanks, Leon Side note, thanks for all the help so far from all.
-
-
Will a manual trans out of a 1980 2.3 turbo mustang bolt up to my pinto 2.3 that has an automatic. Probably a stupid question, but I have no knowledge on this, just learning.Thanks, Leon
-
Yes it has the 2.3 that needs rebuild. It does have the D4 intake if that is a good one.
-
Picked up a 77 Pinto to build for my 14yr old. Here are the engine rules. Any advice on what must be done VS high end options would be very helpful. Engine Specifications: A (4) cylinder family...
All times are GMT -5. The time now is 05:21 PM.
|
|