Search:

Type: Posts; User: Racingtech

Search: Search took 1.36 seconds.

  1. Replies
    4
    Views
    2,989

    Moldymundoon is 100% right that will work

    Moldymundoon is 100% right that will work
  2. Replies
    4
    Views
    2,699

    On the left rear it keeps the tire loaded when...

    On the left rear it keeps the tire loaded when the car rolls over, if your spring is short and it rolls up and off the spring you have no bite untill the car transfer's the weight back to it.
  3. Replies
    6
    Views
    2,891

    I have seen bell housings that didn't line up the...

    I have seen bell housings that didn't line up the trans straight with the engine. Good luck
  4. Replies
    2
    Views
    1,194

    How much? Is it a full frame?

    How much? Is it a full frame?
  5. Replies
    2
    Views
    2,192

    If you Listen to Stock car Driver, and read his...

    If you Listen to Stock car Driver, and read his posts on springs and rates you will be on the right track.
  6. Thread: Rear rotors

    by Racingtech
    Replies
    4
    Views
    1,141

    The piston needs to come out far enough for...

    The piston needs to come out far enough for brakefluid to be behind it or you wont have good pressure on your pads
  7. Replies
    1
    Views
    920

    Gear ratio for tazwell speedway?

    Does anyone know what gears ratio the modified street car run at tazwell tenn. Its high banked and one third of a mile.
  8. Thread: exaust glow

    by Racingtech
    Replies
    17
    Views
    2,953

    Fuel burning in the exhaust can cause the exhaust...

    Fuel burning in the exhaust can cause the exhaust to glow. How it gets there can be caused by several things, To rich , miss fireing, if you are running a HEI ign, check your coil they can overheat...
  9. Thread: Oil pan???

    by Racingtech
    Replies
    5
    Views
    1,309

    If you are talking about a sbc 400.

    If you are talking about a sbc 400.
  10. If a race is 30 laps, then run thirty laps

    I don't think its right to advertise a race to be 30 laps and then only run 15. With all the expense that it takes to get to the track and race, we should be able to run the full race. If a fast car...
  11. Replies
    18
    Views
    5,438

    I was there

    I was there last night and I think Joey and Tiffany did a great job. Alot of things happened that were beyond thier control but were handled the best that anyone could have. I was sitting in the pits...
  12. Replies
    14
    Views
    2,620

    The plastic fan will work

    I have used the plastic fan for years with no prblems even on hot days. You have to have a good shroud and space it up close enought to the radiator. I have had the metal steep pitch 4 blade pull the...
  13. Roller lifters with a small base circle cam

    I have a sbc block that is right side dipstick, 80 to 86. It was a factory roller block. My question is what roller lifters would I need to use with a small base circle cam in this block.I am...
  14. Replies
    11
    Views
    2,695

    I have had good luck with the sir rods in lower hp motors

    I'm not disagreeing with anyone here but I have a 355 that has sir rods in it and it has seen 7600 plenty of times and it was built in 2007, still going. from what you are saying it doesn't sound...
  15. Replies
    12
    Views
    5,928

    solution

    I had the same problem. Get a victor reinz seal # jv1603 made for line bored engines. It solved my oil leak in a 406 race engine. Good luck
Results 1 to 15 of 15

All times are GMT -5. The time now is 08:10 AM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.