Search:
Type: Posts; User: lazer16
Search:
Search took 1.20 seconds; generated 27 minute(s) ago.
-
I am in need to two padded rockers for a 2.3 ford hope someone has some laying around
-
not sure of the year numbers on the side looks like RF E3ZE 5015 00 then it has 88 L02 and yes there stamped .25mm where would the year on the block be stamped thanks
-
I have some main bearings that came out of a 2.3 cant find anyone that has them they are clevite the number on the back of them are 3546cp the center bearing has MB2613p I have not tried the race...
-
I am looking for some main bearing for a 2.3 but no luck finding the # that on the back hope someone can point me who would sell them the # on the back is 3546cp and the # on the center bearing is...
-
I am looking for some set up help on a new car mustang I just need a good starting point then make small adjustments here is what I have RF 650 LF 600 RR150 LR 175 the scale readings or left 52.6...
-
A Great new way to post them unwanted parts or maybe find that that part your looking for. Stop in join and start posting https://www.facebook.com/groups/454744114612253/
-
A Great new way to post them unwanted parts or maybe find that that part your looking for. Stop in join and start posting https://www.facebook.com/groups/454744114612253/
-
A Great new way to post them unwanted parts or maybe find that that part your looking for. Stop in join and start posting https://www.facebook.com/groups/454744114612253/
-
-
I am trying to get more left side weight on a mustang ministock can someone tell me some ways to transfer weight to the left side with out adding weight
thanks
-
Are you running T5 trans what throw out bearing is everyone using with the T5 I have the longer ball but looks like I will need a different bearing. the one I was using will not work the shaft on...
-
Can some one help me with drive shaft length I have a mustang I changed the trans to a T5 now the drive shaft is to long. the measurement from the rear of trans to the flange on the rear is 48 1/2....
-
I just got a bronze gear and found this on the bit size can not find a #13 or .185 can someone tell me what size will work thanks I have looked every where is a a Conversions that will get me close
-
Question I have lost the washer that goes on the Dist with the bronze gear on a 2.3. Is it OK to not use one or do I need to see if I can order another one, looks like it would be ok but would...
-
get your adds out on the all new facebook page https://www.facebook.com/RacingPartsGarageSale. what better place to get it out where millions can see it and what better place to post for that hard...
-
get your adds out on the all new facebook page https://www.facebook.com/RacingPartsGarageSale. what better place to get it out where millions can see it and what better place to post for that hard...
-
get your adds out on the all new facebook page https://www.facebook.com/RacingPartsGarageSale. what better place to get it out where millions can see it
-
I need to change the tail shaft on my pinto trans and install one from a mustang to go into the mustang was told I need to do this for it to work in a mustang is this true and if so how hard is this...
All times are GMT -5. The time now is 04:15 PM.