|
|
Search:
Type: Posts; User: JJRT
Search:
Search took 0.24 seconds.
-
is there a certain sweet part number to get, and what servo is best 235 ? or ?
-
looking for ideas on which sweet , rack and pinion would be best for a 2013 mastersbilt Gen X
-
another question on a mine is a 2013 gen x question is about what spacers do you use between the inner tie rods and the rack
-
ok so if i,m running left side 34 " and 36 " right now and i go to a 35 " right side axle lenght will this tighten the car up on dry slick track corner entry off gas ?
-
what ar the proper axle lenghts for a older gen x 2008
-
courious to what spring smasher #s for a 2008 smack with gen x front end would be -steel block aluminum heads
-
and please explain left or right on the top or bottom
-
is it best to have the top angled forward or backwards in relation to the bottom of the fifth coil ?
-
so on an 2008 gen x approx amount of left rear drop is ?
-
do you raise the front and the rear of the engine when running a steel block ?
-
ok so if you dont have ballast weight in the car , to move ?
-
ok so what if you run a motown block, and your driver is heavy and your car weighs 2480 driver in --
do you still run the same springs and lift bar spring ? on a dry hard slick track that takes...
-
? $$$$$$$$$$$$$$$$$$$$$$$$$$$
-
what degree pistons are in the 430 short block ..
-
so what rotating assembly did it have in it
-
is the oil pan rail standard or wider ?
-
is this still availible ?
-
i run mine around 32 degrees total advance, and it works good ..
-
its a 1998 pontiac grand prix, no amp, if the fuse that runs the radio and heater etc are pulled , no draw
-
I have a parasitic draw on the battery. The only fuse that makes a difference when pulled is number 29 under the hood listed as Radio Bat (10 amp). When I pull that fuse the draw is gone, car will...
-
just a question what all is needed to switch from open engine rules to crate engines, as in what all does one need to get besides the engine its self ?
-
-
how does it prevent horsepower loss ?
-
thats a 2 inch round tube 2006 mastersbilt
-
how heavey should a masterbilt way in with a 280 pound driver steel motown block engine.aluminum headed though.
All times are GMT -5. The time now is 08:50 AM.
|
|