Search:

Will very minimally limit travel if at all if you setup the shock right

Should a mechanical fuel pump hold pressure after you shut key off? Also I have noticed my pump puts out 7psi but it can warm up and sometimes drop down to 3 psi. What could be the culprit?

What's the proper preload for valve lash. I've read 1/4 clear to 3/4 of a turn after 0 lash

Looking for help with rear percentage in a sport mod with 602 crate and left side percent?

Yes correct and as it gets up on the lr it allows it to move a little farther forward as well

Typically when changing rear springs on northern sport mod what method do you use to keep the corner weights close to the same? Just looking to see what people's opinion/methods are

31 shows on it was a backup motor to my open motor. As from gm with GM seals, only ran Brad Penn and changed every 4 nights $2500

What's everyone's thoughts on the best pressure cap to run and why?

What's everyone's thoughts on the best pressure cap to run and why?

Has anyone ever used the marine battery

I have recently bought a new car. The steering takes much more effort to turn then my old car is there an adjustment I can make on the box to make the car steer easier?

Yep I run them in mine.

I bought a chassis recently and learned the lower control arm mount bolt holes were notched out and moved so that the lower ball joint is moved forward. Is there an advantage to this? To me it has...

3dracer I tried to send you a pm but your box is full

Looking at buying a billsbuilt anyone have any good or bad things to say about them? How do they compare to other cars out there??

whats the price without quick change?

Would it help on a 2 bar car like a sport mod with springs on top housing solid bird cages? We add bar angle to gain traction on the RR

What does a chain do on the RR?

What's the purpose of a chain on the RR?

Also up your rear percent around 58% for an open motor 56% for crate will help drive off get more bar angle in the lr will tighten exit rr should be atlest 5° and trail the rr 1/4 to 3/8" and start...

Are the springs on top the housing?

Can anyone tell me what brand this drive flange is. Its aluminum. And bonus if you can tell me where I can get one.

How long is your yoke? If its a 3 speed trans the splines on tailshaft will only give you a little over 3 inches inside the transmission before the yoke bottoms out.

Dirtmod13 don't you have your rf selections backwards? 3/5 for tacky and 3/8 for slick? As to tie the rf down when it's slick. Or what's your reasoning for less rebound when it slicked?

There isn't 500 to 600 dollars in bolts! That's a crazy figure for bolts. But it is the small things that add up fast putting one together. If its a chassis that has been disassembled and everything...