|
|
Search:
Type: Posts; User: cheaterleaddog
Search:
Search took 1.14 seconds.
-
These filters were originally designed for gas pump filters at gas station(they are still used on the filler hose today not to be confused with break away valve for the person who drives off with...
-
I use 4 prong two position switch. If you buy a quality switch panel it will have a switch like this on it. Always use screw connections not spades. I would suggest a cole hersey switch. They are...
-
1998 United Express 34 ft stacker trailer. Pivot lift. Lots of cupboards for storage. Can haul multiple vehicles easily.
-
2012 Sidebiter full roller with 14 updates sat on pole of Super Nationals. Finished 5th $11,000.00 OBO
2015 sidebiter 10 nights on car will have Ruter racing check everything before sold!!...
-
I remove the shaft out g body stock steering columns since the column is inside car they are in great condition unlike the ones located under hood the small end is 3/4" and the other end is double d....
-
Install good accurate gauges and figure out how many turns it takes from all the way out to get to the percentage you want than start over every night before feature. This way you will not need...
-
When you drain rearend does oil flow out steady and evenly or does it burp? If not smooth I would bet on clogged vent. Also do not pull axles out all the way this what tears seals only pull far...
-
Calipers get mounted at angle to not hit frame.
-
-
Depends on what your rules say about rear end location. Do you have link to rules?
-
-
I recently built my second jig. I would not go with flat table design, to hard to access bars from outside. Tips I have for you Make sure totally square so can measure from any rail of jig to keep...
-
1999 , 30 foot stacker everything works. winch for top ramp lift no winch on bottom new tires good torsion axles....
-
yes and yes Not guarantying that if dry it is not leaking but if wet it is leaking. There is a tester for them but power valves are cheap just replace. They do make high flow power valves.
-
406 with 14.5 to 1 pistons machine domes to fit in 50cc heads. Don't know what final compression was but worked great. Had it so close that the valve would leave a imprint on carbon on top of...
-
A blown power valve will sound blubbery or fat at idle. If you take metering block off and it is wet behind block power valve is bad. I would recommend changing plugs also.
-
I would go with pro-tools, made in USA! The bender that they give free blueprints for works great. If you get a hole saw notcher make sure it is made out of very heavy steel to reduce flex. I use...
-
2013 side biter chassis with 2015 updates. Just finished 5th at imca super Nationals sell as roller $13000.00
-
bluecoilspring.com I called to see about getting a special height and rate spring made for a customer of mine, the secretary told me the engineer was busy and she would take my info about what I...
-
Who makes the best rear end mounts to put a quick change in a metric car?
-
I think they recommend to scale without driver so that when people call in for help the car builder does not have to take into effect the weight of driver, I think should scale with driver in car. ...
-
That would be a 1-2 leaf spring finish on one of those occasions James Slawson/Mark Noble both on leaf springs. I believe they were both in pro chassis cars also.
-
What are you gaining off treated plugs and how much power?
-
Now im dazed and confused.
-
I bet you have a 1300 # right front
All times are GMT -5. The time now is 12:20 PM.
|
|