Search:

I am looking for a set of sbc flat top pistons, 4.060 bore, for 6 inch rods, 1/16, 1/16, 3/16 rings for a steel sportsman motor. Let me know if you have a set you want to get rid of. Thanks.

bttt............

bttt.........

Not interested in trades right now. Thanks for looking.

bttt...................

bttt................

car34, check your pm.

eagle, the date built is April or May of 2007. It was purchased from NeSmith Chevy February of 2008 and not raced until August of 2008. Let me know if you guys have anymore...

bttt.........

bttt...reasonable offers considered

bttt.......

***SOLD***

604 as it comes from GM. Original GM bolts. Approximately 60 nights on the motor, mostly local track races of 25 laps. Located in Opelika, AL 36804. $3000.00

We are putting together a motor that has been mothballed for a while. It has a Brodix HV1003 intake with the 4 hole turtle spacer molded into the plenum. I want to run an additional spacer...

I think you are on the right track. I would check the spring pressures and reseal the headers. I don't like gaskets, personally. They always leaked on me. We use Ultra Grey RTV to seal the...

If you have not already, make sure it is getting power. I have had ignition toggle switches fail. They sometimes start to slowly before they go out.

If you don't mind me asking, how low were the jets in your carb? I just what to have a baseline for what is too low for myself. Sorry for your trouble.

If you are talking about the overall droop of the rear end, anywhere from 12-14 inches. Get a limiting chain or strap type device, start at 13 inches and adjust for comfort and track condition. If...

www.pitstopusa.com has them. $9.85 per pack of 4.

3/8-16 threaded bolt for both.

bump:cool:

That's the one. The round one's will work, but I like the square one. They seem to hold up well. Make sure to lube the piston and seal good on reassembly.

I also used outlaw o-rings when I rebuild mine. Worked great.

Ours is from PST. 2x on the having one with the ball spline!