Search:

Anyone make non adjustable fuel log with 9 3/4 space outlets for HP carburetor?

When checking the fit of Rear Main Seal in housing bore, what does most builders do to correct the over crush of the seal halves that causes seal to not be concentric to the bore and will most likely...

It's not lobe wear I am concerned about . it is breakage. Never had breakage problems till had to start running a RPM chip rule.

Any one ever use Earl's preasure master valve cover gaskets and if so will they hold up to a high heat application like on pro action 14 deg. cast heads?

Who tends to supply the best Flat Tappet Cam cores and lifter combinations?

What is the best flat tappet valve spring to use for durability in higher rpm application?

When using a upper ball joint holder such as afco or outpace is it better to use the clevis on the front or the back or does it matter?

Have a new sweet GM steering gear that doesn't fit Chevelle frame due to casting has a flat place on it on front side next where it mounts against frame. Any one ever have one of these and is it ok...

Has anyone ever tried to remove the wheel studs from a Frankland or Winters style 5 on 5 floater hub? Sounds easy but they seem to be pressed in so tight that I'm afraid I'm going to bust the Hub.

Does any one know who has or where I can get a pair of new genuine Afco 5x5 steel rear hubs? Afco does not show them any more. I think the number was 30535.

2005 Mastersbuilt Smack Roller for sale. Car has only been ran 3 times last 2 years. Never bent in Excellent Condition approx 45 nights total. Best of the best including Butler Built seat,...

What happens inside a GM PS Box when it turns more one direction than it does the other? The splines are not twisted on pitman shaft.

What happens inside a GM PS box when it turns more one way than it does the other? Splines are not twisted.

Am I correct in that the rear cam plug on Little M block has the cup side facing inward and is flush with the rear of block far enough to install it?

Whats the opinions on using 5/16 x .105 pushrods in roller motors. I know some are using 3/8 & 7/16 but clearance is an issue.

What is the better way to go? Use for example fel pro 1034 or New MLS 1144 or Cometic type MLS? Pros & Cons?

I used to run that same pump setup. After a long period of time it will drain back and would usually never reprime. I would have to take output line off and pour oil through pump. Those pumps work...

Timing 34 using late model plus fuel. I also have quite a challange keeping a valve cover gasket in the left side. Exhaust heat on center is so close it is really hard to keep a gasket. Right side...

Bore is 4.125 Little M block using pro action 14 degree heads.

Does anyone have any advice on a better head gasket for steel head small block GM to keep the center cylinders sealed better. I realize it's an age old problem but you never know what better gaskets...