Search:

Not my favorite lobe,but yes I have.I prefer more rocker & less lobe.Lift may end up same at valve but I think and have found that less lobe lift is easier on lifters.

9* stuff is about 10 year old technology.About every engine builder tried them without a lot of sucess.Tony Clements says the intake tract is too long but should run great with something like a turbo...

Sold-sold-sold

Stealth lightweight aluminum 1.390 venturi (850) gas carburetor.
$650.00 plus shipping
Pictures are available by email
EMAIL : terry.marciaburnett@gmail.com
PHONE : 1-865-567-6943

Carb is at Stealth for rebuild.

13* Jay D1ckens Heads for 4.5 bore spacing
1.75-1.65 T&D shaft rockers
Stands & hardware
2.220 titanium intake valve w/7mm stems
1.650 titanium exhaust valve w/5/16 stem
PSI 1579 springs &...

Try Joe at HVH.He is a Brodix dealer.I wouldn't turn any engine 8700 with stainless valves.After 7700 on a 4" stroke you will start jerking wristpins.All engines have a critical piston speed.After...

If I were going to change intakes I would put on a ported Brodix BM1000.Camshaft depends on rocker ratio but for that size engine 264* @ .050 w/1.7-1.7 rockers ground on 108* & installed on 102* will...

The -10RI is a better head & your 430ci can definatly use it.However I don't think you are getting the most out of your Dart Pro1 heads.640 hp is way short of what a 430 with that head is capable...

Sold-sold-sold

Relisted on another ad.

Information not accurate

No longer available.

Sold-Sold Sold

Sold-sold-sold

Let me say up front that I don't like crate engines.That being said,it is insane to take a brand new engine apart and blueprint it without dynoing it first.Sure,if you got one that was built by a...

2 or 3 hp.

TNSLIDER,
I don't do pm's but you can email me at terry.marciaburnett@gmail.com
By the way for anybody that might be interested,I have a set of the Brodix T1 11 STS 245 that are used for sale...

Carburetor minimum requirements:
Cubic inches devided by two(you only have 4 cylinders sucking for each rpm)
Multiply by maximum rpm intended to run
Devide by 1728(cubic inches in a cubic foot)

Yellowbullet.com is a lot like 4m except it has more tech advice and even has a mini porno video section.

Chad Spier is on yellowbullet.com all the time.

Brodix has a new intake that is bigger than the 2925.It is called a BM1000

I don't start dyno pulls until 4500.Motor will never see 3500 unless it under caution.

Engine has been rented out.

Just finished another 362ci with Brodix Track 1 heads.Heads were 245cc intake runners.Peak numbers were 647hp @ 7200 and 514# torque @ 5500.