|
|
Search:
Type: Posts; User: Shane2403
Search:
Search took 0.20 seconds.
-
I have a 358 chevy 4 bolt main. It has a Summit Rotating Assembly that is balanced. Forged rods with nodular crank and Hyper pistons and Summit rings. King bearings. The cam is Elgin 1090 with...
-
Thread file works about as easy as anything.
-
Rebuilding a bert trans, the clutch spacer was pretty chewed up so I am replacing it, the old spacer came off hard, do I need to press new one on? Seems like it is going on pretty tough and looking...
-
I had some issues this weekend with bert, it sheared roll pin off for forward gear and pulled shift rod out, so like a dumba** I tried to push it back in to get it to the feature, got trans out going...
-
Will lowering the right lower bar loosen the car on the entry?
-
I just got a used bert, supposed to be ready to go, when I installed it the shifter seems to move easily to low gear and will go into the high gear when I roll driveshaft to line up splines, I can't...
-
I have ran them both, I seemed to always have some heat issues with powerglide under yellows. Low was too low and high was pushing it hard against clutch pak. We ran it off the clutch not off the...
-
Where is this car located and can you send some pics to shane2403@gmail.com
Thanks
-
I have a 350 block bored .30 over with a cast crank, block has been lined bored and decked and squared, bore does have some where, crank is used. I am located in Ohio north of I-70 and 5 miles from...
-
price is negotiable. Thanks
-
I have a 1999 Harris mono-leaf coil over with a lift bar for sale. This is a complete roller. Comes with floater rear end, Kirkey seat, almost new 26" radiator, recent belts, wilwood pedals, power...
-
I am making a lift bar from a quick change fit my 9", is there certain angle to run it or just parallel with the pinion angle? Thanks
-
Will you send some pics to shane2403@gmail.com. Thanks
-
Does anyone know who produced a mod with a metric frame with chevelle lowers? I am still trying to find out the manufacture of this chassis. Serial number starts with GDBK. Thanks
-
Still working on car, I have a couple questions for the experts, what is the minimum spring base that is effective. The way it looks now, with the frame rails being 40.5" to the outside, the...
-
I am in the process of converting leaf over to 3 link, should I use the long pull bar with the progressive spring and if so, what spring to use. I have thought about the panhard bar in the rear of...
-
In the process of changing leaf spring over to 3 link. Rear end has everything on it, just not for sure how to put coil overs on it. Right now the frame width is 40", rear end is 60". There isn't...
All times are GMT -5. The time now is 05:59 AM.
|
|