Search:

What are you gaining off treated plugs and how much power?

Now im dazed and confused.

I bet you have a 1300 # right front

If you set it back to ride height it really should weigh the same.

Those screws are used to set ride height. I know your not in a nextell cup car, but when was the last time you saw them use a weight jack, maybe after a spring rubber adjustment they might use a...

I know a team that switched to a Hughes and they were told have to learn to set up a car some time. No help from him.

I pm'd you

1st swap front springs and try it. 2nd soften rf 50#s and try it. 3rd soften right rear

Captain going to ford, Matt going to captain just my bet! captain = Penske

what is the moment of inertia on a drive shaft that is 52" long and save even three pounds on. I bet at that diameter, it isn't much but maybe I am wrong. If I took a pound off the crankshaft...

Our rules say no lightened gears. I know quick performance offers a carrier that is star shaped and only uses half the ring gear bolts. What I was thinking of doing was grinding away metal on every...

does the light come and gauge reading coinside with each other

[QUOTE=Dirt Knife;1548645]springs 925 LF 900 RF
Rear 225 LR 175 RR

3 link PH Bar 11.5" LH frame height 8.5" on rear end

Have to run the stock mounting locations for the metric chassis so...

looks to me like it was a really good tight race right up to the point of the pass in the grass and slid up into driver on out side and then turned around. Looks like racing deal since he was in the...

start over how can that be 45.28 rear. start putting car on diet start at front of car aluminium bumper and hood, then for every pound you take off put that much lead on left rear until you get a...

maybe worthington

I looked up at cam gear and it looks fine. I kind of believe that it could be soft gears because the dist. I was comparing it to has only been in a gm sealed crate with 5w40syn and it shows same...

I have a engine I am helping a guy with that is wearing off the dist. teeth 360 small block, aluminium intake, $300.00 dollar camshaft non roller, after market dist. no bronze gear, I measured...

Brad I pm'd youplease respond

I owned a hobby car in the mid 90's before they had a cubic inch limit and compression ratio limit so were running against 406 and strokers. I had good drivers. here are the specs 360 ci, 8.8...

I beleive you will find that you need a little heavier rear springs with your soft front springs. Before you change back to what you currently have try a stiffer compression right front shock if...

Some times the fuel gets sucked out of vent tube and you can't see it. I bet the needle and seat has a piece of dirt in it or dried old fuel. if you remove bowl and then attach a clean rubber hose...

just saw on a early post that 15 years ago dynoman was playing cards with some pretty heavy hitters in nascar the one that stuck in my head was Kayne well 15 years ago Kasey was 16 years old. That...

In his early post on 4m he said he had 1200+ 4m customers now he is down to 600 I beleive that.

8 guys and bars or lumber to go under frame to carry car with can go any where. set nose of car on trailer with a scate board under front cross member and slide it onto trailer. Done this many...