Search:

Can you cut a 2500 crank for .875 Honda rods and if so, what kind of total cc would that give you?

Have a lightweight 2300 engine with 5.7 rods, solid head and big valves that I'm possibly interested in trading to a 2500 or larger bottom end. Just seeing what is out there.

Anybody know what drivers are planning on running this deal?

Bolt in shifter for mustang trans. $20

Looking to gain on the competition without breaking the bank. A lot of them have bigger bottom ends than me, but I'm not really in a position right now to invest in one myself.

I have a...

Thanks for the input. I currently run 4.10 and crank about 7500. It's a hammer once it gets going, but sometimes it's a little too late. Looking for a gear combo that will help me get off to a little...

3/8 high banked and hammer down
Lightweight bottom end with solid head
215/70/14 tires
1.99 pinto trans

What gear would you run?

I have a mechanical fuel pump with an inline fuel filter just after the pump. The last two weeks the car begins to spit and sputter in the heat and will barely even run at all by feature time due to...

Off the rim. 3/8 banked dry slick dirt, 205/70/14 tires. I ran pressures in the mid to upper teens and car handled great, but I popped off the front right and right rear. Since then I've ran upper...

I'm sure this has been discussed on here before but I went back and couldn't find a thread about it. I've popped 3 tires off this year and starting to get frustrated. Some people say to run tubes and...

1.99 2nd gear with a 4.10 rear on a 3/8 high banked dry slick track. 205/70/14 tires and cranking about 7600. The car is a rocket early in the night, but slows and loosens up as the track slicks off....

Currently running a fox body mustang on a 3/8 track without a quickener and the extra steering is costing me time. Can I run a quickener without power steering?

Looking for fox body fenders. Is there a racing site that sells them? Seem like they're getting harder to find.

Engine ran fine most of season, but second to last race while sitting in the staging lane it began to misfire. The plugs were fouled with fuel on them, so I replaced them. The car seemed to run ok...

I know a track that requires you to have a fully stock carb, stock cam gear, and hyd cam. but they also allow newer fuel injected/fwd cars to run. Does one have an advantage over the other?

I had a car slide up into my left front this weekend and bent the inner tie rod and locked up the steering. Can I just replace the tie rod or does the entire rack and pinion likely need replaced?

I had a car slide up into my left front tire over the weekend and it bent the tie rod and locked up the steering. Can I just replace the tie rod or does the whole rack and pinion assembly likely need...

New to racing and was wondering what is the best oil to use in a ford 2300 mini stock engine