Search:
Type: Posts; User: Dirtracer18
Search:
Search took 0.19 seconds.
-
By geometry and static number do y’all mean the camber on control arm angle?
-
I have a 2015 blue/gray rocket that has longhorn uprights and upper control arms. I want to put a 8 1/4 upper back on the right front but I need a spacer block to go between the upright and the...
-
What are the benefits of the zero index set up on the left rear and the right rear? And if I were to put this set up on a 2015 blue/grey rocket what all would be needed to do so without having to buy...
-
They must have quit making it. Cause I was told by Robbie that they made one. But I do know that Robbie does not work there anymore
-
It adjusts up and down but it move the engine over. All of the bell housing bolt holes and the dowel pin holes are moved over
-
Rocket sells a mid plate that moves the engine over 1 or 2 inches I believe.
-
Advanced Technology Motorsports Griffin Georgia 770-412-0938
-
What is the best kind of headers to use for a steelhead motor? Mainly wondering about tube size and collector size
-
what is a good starting point for load numbers on my 06 blue front rocket?
-
Yes have a bumpstop on the right front. Does not have a raised crossmember. I don't feel it bottom out. Haven't been on a 400 rf but have been on a 350 and 375.
-
J bar is 9 3/4 on frame and in the bottom of the pinion
-
i have a 06 blue front end rocket with the wide rf. no matter what the track condition is the car will not rotate on entry it just plows the front end. LF 550 RF 275 LR 200 RR225 Left 54.4% Rear...
-
mine got bent Saturday night and I need a new one. I know what length to get but do I get the straight ball joint holder or a 7 10 or 13 degree holder. what effect does the degreed holders have?
-
what is the best way to remove old bearings from a birdcage and install new bearings?
-
can some one tell me what handling changes would happen if I run my car with the right front on the outside holes
-
I am trying to rebuild my servo. It's the old style servo that is separate from the rack. Does anyone have a parts breakdown of this thing. Need to figure out how to get it apart
-
does anyone know what kind of brace the outpace lift bar uses. I am looking at getting one to put on my rocket
-
I have an 05 rocket that I was told has a 2011 front end and I think it has a blue gray front end. Can anyone tell me what to look for to know what front end it has. Spindle heights lower control...
All times are GMT -5. The time now is 09:55 PM.