Search:

it had 40 lbs at idle and 70 lbs at racing. Ran a heat race and when i let off to exit the track, the oil pressure light came on and the guage read 20 lbs. I let it idle for a fews seconds to see if...

Do all bowtie blocks require 2 inch cam bearings? If only some of then how do you know which ones take regular cam bearings and which one takes all 5 2 inch bearings. Do they take special oil...

no numbers on a shaw

I would like to know what the difference between the standard sbc 2 piece rear main seal and the line bored 400 rear main seal? What happens if you use a 400 line bored seal on a 350 block? Will it...

I think he is talking about using a HEI dist to trigger the msd box. yes it works fine.

with a mechanical pump we never could get the idle down to 2-3. we just set it at max. pressure of 8 and it idled close to that. It will sometimes lift the needles off the seats and flood at high...

yes the camaro is 11/16 threads

use a metric center link inner tie rods with the bends are from a 80 camaro. tubes are 10 inches long but will have to have 11/16 lh and 5/8 right hand threads. you can buy those tubes from pierce....

Anybody know what chassis Chad Kinder is driving in Florida? thanks

1186-18 is the correct part number

Anybody know where any buick v-6 parts might be laying around gathering dust. Have a drag racing buddy looking for a block?

i bought mine from tony barker. Don't know what brand they were. Maybe he will come on here and let us know.

i have a refrig. fuel cell and i can only get 27 gallons in it.

His name is David Young and yes he lives in searcy ark. Here is two old telephone numbers for him. 501-268-1767 or 501-278-7224. I haven't tried to call him in a few years so i don't know if they are...