Search:

Type: Posts; User: MM90

Page 1 of 16 1 2 3 4

Search: Search took 0.98 seconds.

  1. Replies
    65
    Views
    20,793

    How long does a race have to be in existence to...

    How long does a race have to be in existence to be considered "Crown Jewel"?? 10years?

    I also don't consider money to make it a Crown Jewel race. And this is a track I raced weekly at.
  2. Replies
    12
    Views
    3,212

    That's what I noticed the most when I went from a...

    That's what I noticed the most when I went from a straight spring rate to progressive. On a hooked up track where you might be off throttle and then wide open you will notice it hooks up slower, I...
  3. Every NASCAR driver has said that at one time or...

    Every NASCAR driver has said that at one time or another.
  4. Replies
    7
    Views
    1,966

    Had same issue, shortened driveshaft 1" and never...

    Had same issue, shortened driveshaft 1" and never had a problem after that.
  5. Replies
    123
    Views
    14,749

    True, but if they settle it will set a precedent...

    True, but if they settle it will set a precedent for future litigation that ultimately will not be good for the sport.
  6. Replies
    123
    Views
    14,749

    One thing is for sure, this case won't get...

    One thing is for sure, this case won't get settled anytime soon.
  7. Replies
    6
    Views
    2,374

    On chevelle stub, measurement is 7-1/4" or 7-3/8"...

    On chevelle stub, measurement is 7-1/4" or 7-3/8" if I remember right. That's lower control arm bolt to ground. I always followed my chassis mfg spec, but when I measured the bolt to the gorund they...
  8. Replies
    16
    Views
    3,103

    So if you ran a scoop backwards, would the air...

    So if you ran a scoop backwards, would the air over the deck siphon the air from under?
  9. Thread: XR-1 Rocket

    by MM90
    Replies
    70
    Views
    23,374

    55K and all you need is engine and seat. So it's...

    55K and all you need is engine and seat. So it's not completely out of line, still a tad high for a 1 season old car.
  10. Thread: sbf on alky ??

    by MM90
    Replies
    5
    Views
    1,660

    KSE Tandem on ours, also ran a belt drive BLP...

    KSE Tandem on ours, also ran a belt drive BLP fuel pump. Both worked well.
  11. Replies
    7
    Views
    2,335

    I wouldn't go any softer than 800#. Going from a...

    I wouldn't go any softer than 800#. Going from a solid to a 1200# may not be a huge difference, which wouldn't necessarily be a bad thing. Honestly if you are fast with what you have a solid bar can...
  12. Replies
    10
    Views
    2,909

    Guys don't build cheap engines anymore because...

    Guys don't build cheap engines anymore because they are buying reliability. Problem with chip rule now you can't spin a 355 over 8k like the old days. Valve float was the original rpm limiter. lol
  13. Replies
    6
    Views
    2,472

    I liked lower gear in my car, but my engine also...

    I liked lower gear in my car, but my engine also liked to be lugged more than screaming rpm. Going from a 5.29 to 5.14 9" made a big difference for me. So there are a few variables, the beauty of the...
  14. Thread: RaceCeiver volume

    by MM90
    Replies
    10
    Views
    2,848

    I used the earfuze and liked them. Also don't...

    I used the earfuze and liked them. Also don't have the volume at max on the raceiver. Go one volume level below max.
  15. Replies
    8
    Views
    2,557

    Ricky Thorton Jr?

    Ricky Thorton Jr?
  16. Also to add... If these track promoters complain...

    Also to add... If these track promoters complain about social media, but then use it for their own promotion. You can't have it both ways.
  17. Replies
    9
    Views
    2,529

    Last couple I watched the sound was off so far...

    Last couple I watched the sound was off so far they were idling down the straights and hammer down in the corners.
  18. Thread: Chain on 3 link

    by MM90
    Replies
    6
    Views
    2,003

    On a 4bar car, I would think it would work the...

    On a 4bar car, I would think it would work the same on a 2 bar. If you chain the RR it's to keep the chassis from climbing off the RR spring on to the bar(s). Chaining the RR down can tighten the car...
  19. Replies
    4
    Views
    1,698

    90lb/ft is what we torqued all of our wheels down...

    90lb/ft is what we torqued all of our wheels down to.
  20. Replies
    3
    Views
    1,795

    JDR, VDL, Willy's probably in that order.

    JDR, VDL, Willy's probably in that order.
  21. Replies
    8
    Views
    1,928

    You can get deck mount oil coolers in -10 and...

    You can get deck mount oil coolers in -10 and -12. My engine builder liked -12, and that's what I ran on my wet sump engine with an external oil pump.
  22. Replies
    8
    Views
    1,928

    I sure hope he isn't using AN6 for oil cooler...

    I sure hope he isn't using AN6 for oil cooler lines. But just as a reference if it was AN12 like most would it be double?
  23. Thread: The EPA...

    by MM90
    Replies
    52
    Views
    8,914

    And people think Social Media is the end of Dirt...

    And people think Social Media is the end of Dirt Track racing. LOL It might actually be the thing that saves it if this goes any further.
  24. Does Yelp help/hurt restaurants? Of course it...

    Does Yelp help/hurt restaurants? Of course it does. The good ones get more business and the bad ones don't. Just like any business. It's the way of the world now. Complaining about it isn't going to...
  25. It's more like a UMP or USMTS car with spec...

    It's more like a UMP or USMTS car with spec shocks and crate engines.
Results 1 to 25 of 376
Page 1 of 16 1 2 3 4

All times are GMT -5. The time now is 01:07 AM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.