|
|
Search:
Type: Posts; User: racingford
Search:
Search took 0.58 seconds.
-
recommendations on whos custom built shocks.
-
run a wing on my car a couple years ago didnt change a thing only run around 13 degrees of angle, could of taken some rear pecentage out. had a 4 barrel,
track was heavy and if had more than the 18...
-
too loose in off throttle, looking to up the right rear spring, i currantly have 225 on left and 200 on right rear. my question is do i up it by 25 or 50 or just switch the currant springs. I dont...
-
too loose in off throttle lokking to up the right rear spring, i currantly have 225 on left and 200 on right rear. my question is do i up it by 25 or 50 or just switch the currant springs. I dont...
-
Imca/ump legal 2009 ford stock car, 6500 turn key or 3000 roller.410w, willys carb,2 disc quartermaster,mitchell trans 217 653 2270 located mt.sterling il. Will email pics
-
theres no such thing to my knowledge, I did see a guy use the metric chevys and get pass tech. I want to say theres not much different other that bolt patern.
-
-
clint has tried to respond but having trouble. so I will for him, Its a chevy
-
search these forms, I set my engine back this time last year and I asked the same question before and got a lot of opinions
-
6 inch is said to make more torque on the dyno
-
If I am correct the chevy crank center line was 8.5 to 9 inchs from the bottom of crossmember. you will want to keep in mind the angle of carb mounting. and if to much angle down in back
the oil...
-
car is awesome and fast when tacky, loose on entry, too loose when its dry slick. rearend is square under car and right rear is inside the right front,the brakes to the front helps, my question is if...
-
do you clean these filters or throw them away? have friend that had one on latemodel had power complaints switched back to kn and power complaint went away. filter still looks good and clean though
-
Dave, how can you be rumming 7 degrees in left lower when ump rules states must be mounted up close in stock location?
-
-
I would probably string it and line up the right side and make sure theres no lead and is square. some will tell you to center it and use differnt offsets to adjust the right rear in but going to...
-
need small block steel bellhousing and 7 1/4 clutch 217 430 9512
-
need small block steel bellhousing and 7 1/4 clutch 217 430 9512
-
also need mid plate as well
-
need steel bellhousing and 7 1/4 clutch 217 430 9512
-
great question, reworking one myself. anybody with some pictures and advice on the best mount to buy or does one have to fab their own.
-
ebay use that part #, little high at 100.00 dollars. but nothing compares to one
-
what ever you buy the lithium battery is the only way to go. the gun seems to have the same output all the time, wheather the batterys low or fully charged.
-
-
search modified classifieds for kraft chassis and you might find the #
All times are GMT -5. The time now is 05:20 AM.
|
|