|
|
Search:
Type: Posts; User: huckleberry_hound
Search:
Search took 0.78 seconds.
-
Switched to 604 from open aluminum motor, using same midplate sets 604 too low in rear, when spacing the motor mount to get fan clearance, motor has too much angle,,, do 604’s use different midplate?
-
CT 525, #1 cylinder shoots 200-250 degrees colder than all others with heat gun and motor pops and cracks between 2500-3000 rpm,,have changed msd box, wiring harness, coil pack, plug, plug wire,...
-
Turned out to be a bad msd box Brad
-
Who did the motor work? How old is it? Thanks
-
-
-
Is it normal for these engines to surge at idle when cold until engine temp comes up? Ours has always done this and seems to be getting worse lately, I’m wondering if it could possibly be a coil or...
-
Iso ford headers to fit a swartz chassis
-
Had a guy ask me at the track if E85 would run ok in his bigger cu in motor, probably 700 hp 420ci,,, anyone know if it would? I wasn’t sure if the octane would be high enough
-
MLR your right on ,,, I got it down to 85%. Thanks
-
We’re running e85 on our ct525 and had a guy ask if it will run ok on a higher compression motor, he has a 700+ hp 13 to 1 comp. Anyone doing this?
-
Thanks guys,,, I was planning on being cautious just so I don’t go too far under Brad,,, been using a long blow wand to agitate,,, probably be fine where it is but will play around with it just to...
-
Ok thanks,,, no tech here so should be ok. Any estimate on how much 93 octane it would take added to 50 gallons to lower 2% ?
-
Just bought E85 at the pump today that checked out to be at 87%...running a ct525.. should I try to bring in down or would 87% be ok?
-
Brad how do you recomend plumbing up the holley regulator? do you want to run the 2 out ports , one to each bowl on carb? or can one out port be blocked? hope that make sense...
-
What plug works best in a ct525 and how often should they be changed?
-
Matt, Is the method you’re saying to use wired into the ground (negative) side of battery? I’m thinking when using an alternator, you’d have to run wire from alt. to one small terminal on disconnect...
-
That was my thought,, to cut it open,, wouldn’t think it would be too difficult and alot cheaper than buying a new one
-
what's the best way,if any, to safely clean an oil cooler that has been used during an engine failure?
-
we just purchased a new ATL fuel cell and the sticker on it says the foam that's in it is compatible with gas and e85,,,the sticker also shows a different foam to use when running alcohol,( they put...
-
Will a franklin side bell fit a winters rear?
-
Has anyone had any experience with these heads? Where do they compare with the C3 and D3 stuff?
-
We had this problem and overlooked it for some time until we found the driveshaft was too long and bottoming out against trans... didn’t seem to hurt when track was heavy but not enough drop when it...
-
What fuel pressure do you need for e85 as opposed to running gas? I've been told you can run the same for both but was concerned since doesn't e85 have more of an alkohol content?
-
Ok ford guys, How hard or is it fisible to take one of the nascar roush yates 358 motors and make a 410 or something close to run in a dirt late model? I'm not familiar with ford engines as far as...
All times are GMT -5. The time now is 09:16 PM.
|
|