Search:

Mini Stock #32 Race ready minus motor + rolling chassis (no body) and all spare parts. My car ran twice this year at I25 Speedway in Pueblo, Colorado. Chassis is a 74 Ford Pinto, body has been...

Pretty much common knowledge that the trade off for the strength of a 9" is the extra horsepower it takes to turn it. If your worried about breaking the rearend the most you need behind a 4 cyl is an...

Pretty much agree with all the posts above. Mine is wired with the bottom three wires. Never a bad thing to use the ground wire as long as its done right. I have mine grounded to one of the bolts on...

If you're running a tfi distributor you might try running some cool air to the tfi module, they tend to run really hot and burn up......I would do the same if running a duraspark setup.....

Has anyone tried running an automatic behind the ford 2.3 in a mini stock?
Just curious since there used in street stocks and modifieds quite a bit.....

And the piston kick back springs............

As usual, excellent info from you Dave!!!!

Dumb question time.
Can you use roller followers on a non- roller cam?

You need to your cam specs to know what rpm's you should be turning. Also, you should find out what the other racers are using for a final gear ratio. Your final gearing is 6.59 (2.14 x 3.08). If...

Sent you a PM Mark.

Isn't 4 lines a bit excessive? I would like to hear more about your system though. Does evacuating to the collector free up any hp?

I have seen and ran a block(2.3l) that had the crankcase vent hole plugged. I never had an issue with blow by. I have also ran one with the hole unplugged and had serious blow by through a breather...

Have you tried looking for a part number?

Can't use metric, has to be oem family to family.....

Do you use everything from the escort, bracket, rotor, and caliper?
Is there any fabricating to do?