|
|
Search:
Type: Posts; User: Rtruck
Search:
Search took 0.27 seconds.
-
I know the Mustang is longer by about 6", but will the Pinto drive shaft be long enough to use on the mustang?
-
Just put back on my ND alternator. Top wire (charging) direct to the battery. It has got to be excited and I know which terminal that is. Where should I pull the 12volts from to "excite" it. I...
-
Installed a timing belt/bumped the aux shaft. Tried to time the motor and found turning the dist clockwise I ran out of adjustment (hitting a down bar in engine bay) and couldn't retard the timing...
-
Rob, great schematics! My Pinto finally has the electrical gremlins which have done me in for the last 7 days. Someone smarter than me stated it would best to rewire the car......rather than keep...
-
No, not in gear and I noticed it happened on the front spindles. Didn't check the rear. But not in gear.
-
Ok Dave, had my car on the lift yesterday with all the wheels removed. The lug nuts were on the studs, screwed down to almost flush with the top of the lugs. Ran the engine for about 20-25 minutes....
-
Great, I forgot about the fuel pump, should have included that issue as well. Thanks for the tip on opening that up. By the way, will there be a distributor drive gear on that shaft or will that...
-
Have a '93 2300 Ford twin plug. Want to use the block if I can add a distributor. Appears there is a block off plug where the distributor goes which should be an easy removal correct? Anyone build...
-
Have a '93 twin plug head. I understand the flow numbers are pretty good. Question is, can these things be adapted to run as a single plug with conventional distributor etc for mini stock race...
-
Thanks guys...appreciate the help....3 for racing sounds right.
-
Can't find my old notes on the following:
Need fluid capacity of rear end-8"
Torque specs on pumpkin-8"
Fluid capacity of 7.5" diff.
Thanks,
-
No, not threaded. Will check out the turbo listings...
-
Replaced my valve cover for my 2.3. The filler is located at the rear and doesn't take the same type of cap the 80-84 front fill valve covers do. Question is: what year/vehicle did these come on so...
-
Please bare with me...but....now that I am residing full time in a cold winter area, I am finding little things that I'm sure have quick easy fixes. First, my shop is not heated....yet....not sure...
All times are GMT -5. The time now is 01:43 AM.
|
|