|
|
Search:
Type: Posts; User: Dan Clarke
Search:
Search took 0.15 seconds.
-
Hi,I realize this is an old thread but I'd like to know the pin height above the bottom of the lower ball joint hole. Thanks, Dan
-
Exactly what I was looking for................Thanks for the links..............Dan
-
I can't find where GM lists the specs of their crate engine internals................Can someone direct me to a website please?.............Thanks,Dan
-
I went looking and found this picture but on a site with Asian text, can't read what they are saying about it.............Dan
-
they do...........I'm not going to buy a crate because I prefer to build my own engines,,,................Just trying to get a feel for how exotic I need to be in parts selection for a 2-barrel iron...
-
Also, my rules say crates must run a 6600 RPM chip..........................Would a 602 hold up running up to 6600 every lap?....................Thanks,Dan
-
That's what I have in mind......................... If it's...
-
thanks for getting back..........By "steel" do you mean forged?...............Thanks,,Dan
-
Hi,............do the 602 and 604 grate motors use cast cranks?.................Pressed metal rods?....................non-forged pistons?...................Thanks,Dan
-
You're right. Direct to the pump, no rear pump................Instructions I got on adjusting the low gear band was to torque it to 70 ft.lbs., then back off 4 turns.................I'm thinking if I...
-
Anybody know about powerglides?.....I want to make a push start mechanism for my powerglide but not hydraulic, i want something manual......I think I can use parts from a motorcycle clutch release...
-
Hi, I'll be building an LT1 circle track motor soon and am new to Tucson so am asking for recomendations as to a good race engine oriented machine shop in Tucson. Feel free to pm me at...
-
How the heck do I shape a post to have paragraphs?I type it in several paragraphs but it publishes as a string.Dan
-
Guess not.Can anyone suggest a forum that is focused on asphalt modified chassis setup?Thanks,Dan
-
Hi,Someone here might be able to help me.I was following an asphalt modified forum at the RacingWest.com site and the whole website dis-appeared.Anyone know where it went?Thanks, Dan
-
I'm going to set it up for 2" offset and elongate the mounting brackets so I can move it a little either way if I want to later.Thanks to all,Dan
-
Just spent some time with the new rules, the only engine location rule I can find is 6' forward of the rear axle. I'll see if I can get ahold of Chas Howe for starters.Thanks,Dan
-
Hi,New guy here, building an asphalt modified and have no experience with them. Depending on engine, the rules state between 56% and 58% left weight. How much, if any, of the weight offset needs to...
All times are GMT -5. The time now is 02:07 AM.
|
|