Search:

Anyone have suggestions. Thanks in advance

No reply from pro systems yet. What would be y'alls suggestions on how much to lower jets?

I have a pro systems carb. I can't find paperwork on it. Believe it's about a 800 to 850 cfm. Jets are 76 front and 86 back . Engine starts to overheat 5 or 6 laps into feature and is always hard to...

Are there any race car parts auctions coming up within 100 miles of boston in the next month or so

3 races since fresh. Can give builders number if serious can text me at 919-340-3171 located in nc

This is a 358. Would consider trade for something bigger

3 races sence build. No dist or carb located in nc. Can text for specs $6,000 919-340-3171

what adjustments would you make?

Both are berts but will try grease and lube. I had a modified toyota starter on it for my crate motor and it engages fine but not strong enough for my steel block limited motor.

to start with i dont have any setup numbers with me today. 3/10 track tight corners goes in good middle is good but loose off and no heat in rf tire. Rough numbers I can remember 100 lbs bite 54.8...

tried two different starters and wouldn't engauge. Was told i need to shim the flywheel. My question is, how do I know how much to shim it?

one that is not all scared up. Looking for long yoke also. Can text me at 919-340-3171 thanks

Thanks guys

using a Bert trams. Was told that a regular car and a signature car are the same except for add on's.

Can text me at 919-368-7851

Ive got one where are you located. Can text me 919-340-3171.

Don't know much about it. Was told 750. 250.00 ca text me at 919-340-3171

Don't know much about it. Told it was a 750. 250.00 can text me at 919-340-3171

I've been trying to get a hold of him for a few weeks. Leave messages and no call back. Anyone have a clue why? Thanks

650 750? 1.40?

4/7 swap headers

Can text me at 919-340-3171

Can text me at 919-340-3171

Im not running a sas spec track. So no rules apply

What would be the best cfm gas carb to run. Also do these spec heads take a standard 23 degree header? Also what tube size does best. Gonna go with schonfelds.