Search:

Type: Posts; User: DLB1985nc

Search: Search took 0.57 seconds.

  1. Replies
    3
    Views
    317

    If I put the cam in the head with followers and...

    If I put the cam in the head with followers and rotate it by hand can you tell if it's gonna hit anywhere? I'll have to compress the lifters to get the followers back in so it seems like I'll have...
  2. Replies
    5
    Views
    379

    It was wiring. I took out all the cheap crimp...

    It was wiring. I took out all the cheap crimp connectors and soldered everything, now it runs great, starts great and idles. I swapped out the 2100 for a MC2150 and that took care of a stumble I had...
  3. Replies
    3
    Views
    317

    How much cam lift for 2.3?

    I've come into two Engle hydraulic slider cams, one is .464 lift, one is .485. I've heard rumors the head needs to be milled around the valve guide area if I go over .450 lift. Any truth to that?...
  4. Replies
    5
    Views
    379

    It's not hooked up. I have one but when I...

    It's not hooked up. I have one but when I switched from the E1 to an Esslinger intake I don't have any vacuum port to hook into.
  5. Replies
    5
    Views
    379

    I checked the timing for the 20th time and it's...

    I checked the timing for the 20th time and it's dead on. I borrowed an electric fuel pump for up to 7 psi, no difference. Changed carbs again, no difference. Swapped out the new distributor for an...
  6. Replies
    5
    Views
    379

    Desperately need 2.3 Ford help

    I put together a 2.3 motor recently and I cannot get it to idle or really run at all below 2K rpm. The motor will rev out of the frame but will not attempt to idle. It will idle perfect if I hold my...
Results 1 to 6 of 6

All times are GMT -5. The time now is 12:46 PM.


Powered by vBulletin® Version 4.2.0
Copyright © 2020 vBulletin Solutions, Inc. All rights reserved.