Search:

Type: Posts; User: kn48racing

Search: Search took 0.27 seconds.

  1. Replies
    2
    Views
    1,168

    MBH Mastersbilt Rear End/Axle Length

    Hi all. Just picked up a 2013 MBH close to bare frame for an upgrade. Currently running a Smackdown copy. Current car has 33/35 axles. Will this combo work in the new MBH? I’ve heard people say the...
  2. Replies
    4
    Views
    1,333

    Thanks! I was considering that. I currently do...

    Thanks! I was considering that. I currently do not have a welder suited for aluminum but it may be more cost effective to find a local welding shop that could take on the job for me.
  3. Replies
    4
    Views
    1,333

    Mastersbilt Midplate

    Looking for some advice from the 4M world. Running what is supposed to be a copy of a Mastersbilt Smackdown. Doing some frame updates and would like to raise the engine more than what I currently can...
  4. Replies
    2
    Views
    1,333

    Power Steering Reservoir Cap

    Hi all,Rookie question here. Looking to see if anyone has encountered what I currently have. Running a KSE tandem pump. The instruction state to use a vented cap which is what I have been using. For...
  5. Replies
    2
    Views
    788

    Thanks! I'll work through the detailed...

    Thanks! I'll work through the detailed troubleshooting guide and see if anything will work. I'll just plan to have my old servo rebuilt just in case. Thanks again!
  6. Replies
    2
    Views
    788

    Power Steering Servo Replacement Issue

    Once again looking for advice for a rookie. A few days after my first race I noticed my servo was leaking a little fluid (Woodward remote servo). I had another unknown used servo on my shelf so I...
  7. Replies
    3
    Views
    1,026

    Issue seems resolved now. I followed the above...

    Issue seems resolved now. I followed the above steps and now the shift pattern seems normal. The test drive will come later on at the track tonight.Thanks again!
  8. Replies
    3
    Views
    1,026

    Thank you for the quick response! I'll pull the...

    Thank you for the quick response! I'll pull the transmission and take a look inside. I was a little hesitant to go inside it before, thinking that I may do more harm than good but this sounds simple...
  9. Replies
    3
    Views
    1,026

    Bert Shifting Issue

    Could anyone pinpoint what may be wrong with my transmission?First gen slip yoke Bert. The car goes into low and high, and the reverse shifter stays in “neutral” all this time. Now when the high/low...
  10. Replies
    3
    Views
    837

    Thanks for the replies! I talked to the folks at...

    Thanks for the replies! I talked to the folks at KSE and they were very helpful. They told me it can be done, and they would be happy to do it for me. Although they said for parts alone I was looking...
  11. Replies
    3
    Views
    837

    KSE Tandem Pump Conversion

    New guy here. Has anyone converted an older style KSE tandem pump from 3/8" hex drive to a belt-driven drive? I have two of these pumps (one complete, one in pieces) and both are 3/8" hex drive. The...
  12. Replies
    2
    Views
    694

    Sent you a message.

    Sent you a message.
Results 1 to 12 of 12

All times are GMT -5. The time now is 10:14 AM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.