|
|
Search:
Type: Posts; User: swrracing99
Search:
Search took 1.14 seconds.
-
I'm looking for the longest upper ball joint to fit a metric spindle but the large gm bolt pattern uppers. I'm looking for qa1 and longer than 3/8". Any help would be appreciated.
-
No. I found them at BWRC. Thanks for the help. After looking talon75 yes that's what it looks like.
-
No. I found them at BWRC. Thanks for the help
-
Yes. But larger. The ball looks like it should be abound 3/8 or so in diameter.
-
How much for the battery charger?
-
I have recently purchased a bwrc. The shifter linkages have a quick disconnect on 1 end with a hiem joint on the other. I'm trying to find the male end of the disconnect that will thread into a Bert...
-
Im looking for a baseline to start with on a 2014 bwrc. I have called barrys twice with no luck. For some reason or another they can not email the info. Just looking for springs,%s, bar locations on...
-
-
Talked to hoosier today and found out what I needed to know.
-
How are you guys sipping these tires or are they best left alone, just grind and go. trying to see if Im leaving anything on the table. Thanks in advance
-
Thanks for all the input. Looks like it's all positive.
-
What are you asking for them?
-
Are they worth the money or not. I know Hendrens are very reputable people and have done a lot for the crate racing community, just looking for some input on them.
-
Hoosier h500. Metric 4 link.
-
The vortec heads would be considered a factory head and I do have a set of the bow tie head and the victor senior intake. They have also been angle milled. So you think I would be better off saving...
-
Any flat tappet cam, any intake, and factory head and flat top piston. Any aftermarket head add 100lbs. I have a set of dart iron eagle 49cc heads as well.
-
Trying to decide on a 602 with a 4bbl and weigh 3000 lbs or up to 360 ci and weigh 3200 lbs.and a 4412 2 bbl. Then any ci 9 lbs per ci. Then any iron head add 100 lbs.what are some opinions. Pros and...
-
Anyone have any feedback on these cars. Looking to buy a new chassis at the end of this season. I have been looking for different chassis companies. Anyone know of any chassis builders that are good...
-
Exactly as described. There is a certain way to set it up so you get the same drop as you would on your birdcage. So you can switch from one to the other without changing anything else. We used one...
-
If you are looking for traction in the slick you could put a clamp bracket in front for your lrf shock. Run a dummy with high gas pressure or high compression 0 rebound oil shock on that bracket. Not...
-
-
I was reffering to dirt late model tires. AR 56s. right now Im at 53.5 rear 53.2 left and about 250 lbs of bite.
-
What would you need to change as far as setup by going from a 8" tire to a late model tires.
-
Not sure what your talking about on the 500 hp and the 300 wins? I never said any of those things. All though I do appreciate your input. How could I check my combustion timing, with my regular...
-
Yep on the timing light. I have had 4 other people tell me about the fuel filter and line. Looks like I got some changing to do.
All times are GMT -5. The time now is 04:32 AM.
|
|