|
|
Search:
Type: Posts; User: crate late
Search:
Search took 2.54 seconds.
-
Jackpot Prep can you please send me your contact info?
-
Check your PM's I sent a message about a week ago
-
Mine had the same problem and it was the band. The clutch material had broken loose off the band and and was dragging on the drum inside. Took it apart and replaced the band and it was good to go...
-
If you have never lost a driveshaft, you are lucky. But, everybody's luck runs out sooner or later and the thing that comes to mind is a bush-hog with a steel shaft hooked to a ball spline. Even a...
-
It aint rocket science, it's forgetting all the BS Joe Blow racer told you and all you have heard over the years. Just do what it says and it works. Period
-
Sure you can switch them, but I wouldn't just switch for no reason or until I bent one.
-
Ditch the restrictor all together
-
It will change your location of the crossmember when you put it in the wall! Doesn't change anything
-
All of my bell housings had a grease fitting right beside the starter on the idler shaft. The idler shaft is hollow and accepts grease through it to the gears. Put a pump in it every other week or...
-
I've run schoenfelds and beyeas and can't tell a difference on the track but I have never dynoed them either. I have never had a problem cracking any headers but I always make sure they are...
-
price it no motor, trans, or oil system
-
I like the RRL +1 to free in and once you pick the throttle up if it's too tight raise the LRL +1 to make the car rotate on the gas.
-
I would choose a color thatcan be matched by a spray can because you will eventually need to weld on the chassis or build new nerf bars or nose frames and a rattle can will be the choice for repairs
-
my beyas were just about level with the frame rail. Make sure when you slide the extention on you turn it correctly and come under the second door bar. Should be right in between the first and...
-
That car is a late 2000 or early 2001. Gloss black '96 spindles 16 5/8"ls lower 17 5/8" rs lower. The uppers I can't remember right off, maybe like 11" lf and 10 1/2 rf? There are some differnt...
-
Exactly what I was thinking! Only one instance I can think of..........driver has altercation on track and it spills over to the pits
-
given your weight, I'd say IF you got the lightest trick parts available you would still be overweight and your percentages are not going to be what they need to be. If you use the latest and...
-
This is an awesome carb,custom built for a 604 brand new in April, less than 10 races on it. Our fuel supplier can't get ethanol anymore and we are having to travel 6 hours round trip to get fuel and...
-
If you can't get anything I would reverese bleed it. Take one of those little metal oil cans with the pump handle and fill it with brake fluid and put a rubber hose on the end and hook to the...
-
I would try neg side of the coil
-
Nike makes or did make a driving shoe. They have more padding and support than any driving shoe I have ever tried on. I think I got them from Day Motor Sports for like $100
-
12 lbs on the RR. Is this normal? I usually go for around 10 or 10.5 on the RR, am I too low? What are typical tire pressures you guys are running all the way around the car? I don't mean to...
-
RR on the birdcage or clamp bracket?
-
-
What is the maximum size jets you would typically put in a 650?
All times are GMT -5. The time now is 06:47 PM.
|
|