Search:

headers are sold

as long as you have at least 1.5 inch in the trans ride height you should be fine I just got sold the brinn and bought a bert ballspline

as long as you have at least 1.5 inch in the trans ride height you should be fine I just got sold the brinn and bought a bert ballspline

Did you check the pick up on the distributer make sure it has no rust build up it is what happen to mine I took it apart and cleaned it the it went away

do you still have the bert for sale

do you still have the trans

only need 30 to 60 left rearand less if it is dry

Thanks i fixed that

08 Dirt Works Genesis for sale. Write now it is 4bar 4bar can be 4bar z link .It will be a roller no drive tran no seat or seatbelt. It has afco springs. Intgera shocks 9 inch no gear will come with...

look on Ebay there was one the other day

im in houston tx find out what it will cost

Will u ship

I have all was gone to ACE and got the clear braded line has worked fine

what brake bracket do you have

you can use the regular 3 speed shifter. U will need to put the rod about 1.5 blow the deck for the high low and the reverse about 2 to 2.5 blow deck. It is what i have found to work the best. When i...

will you ship to texas if so call me 832 256 6020

he races at battle gound speedway just east of houston some time if i see him this weekend ill let him know you are inneed of some help

i was having the same problems so i went out this past week end on are week off and hot laped mine i have a dw12 i had 7.5 in rack in j bar. I took it down to 5.5 and got a lot of side bite. What is...

there are uppers that use the stock mounts you can get them from southwest speed
the ball joint i use is moog k772

when you pull the seal out is there a cover on the bearing or can you see throw it if you can see throw it you need to change it i had the problem with mine put some silcone on the washer and bolt it...

that is up to you some people say yes and some say no. I just loosen mine up but a friend of mine took his all the way out . it seames to work both way . JMO

http://www.performanceraceeng.com/

i run a dw 12 and had the same problem so i went with more roll out in the rear and front i run 1.5 to 2.5 in rear and 1.to 1.5 in the front you . Have you tryed to put the car on 4 bar on both sides...

sounds to me you have a bent drive flange not a been housing i have had it happen got hit in the wheel at funny angle Just my 2 cents

you should have a hold up on the left rear