|
|
Search:
Type: Posts; User: juice87
Search:
Search took 0.39 seconds.
-
if you just want car to come off corner straighter run a 2 inch offset wheel on left rear and if that don't work, those shaw cars like to be chained down on right rear to keep car from lifting off...
-
-
most modified drivers want to race against the best.
-
whats everyones thoughts on lift arm vs pullbar on short 1/4 mile tracks with
tight corners?
-
u might want to check ur caster settings also I know this sounds stupid but if u don't have enough split on a rough track will cause car to be darty which will upset the chassis bad. and if you get...
-
to much left rear bar angle take some out tires are acting like shocks.
-
there referring to going into the corner getting off the gas.(that's when the car takes a seat) then you turn and weight from left to right transfers (rotate) moving your j bar or changing spring and...
-
needing a bumper pull stacker trailer
-
i used some of the stuff that came with it and an old bolt on shock mount.
-
sounds like you need to spend a couple days on the scales playing with lead and writing down all your results... plus how about your rr spring table is it even ? also maybe put some angle in rr...
-
-
I run 542 to 555 turn 7400 421 ci quick change.
-
prestiege auto repair in vincennes ....bill claycom kevins dad done them for years
-
i have a lunati sledgehammer fresh.
-
would like to have hubs, drive flanges, bearings and all maybe off an old 9 inch to put on a quick change have mini 5 right now like to change axle tubes and get it to grand national.
-
which is better? the one that mounts to the car im sure would be better, but the one that connect directly on helmet looks like it would be easier to mess with. do they work about the same?
-
whats the address to where the show is in indy or a website?
-
stupid question ive never ran the kse pump but just got my new kse kit in the mail yesterday the big pulley dont have sides on it, did they forget to send the add on or do you not need them because...
-
close to tri state speedway around princeton area
-
i live in indiana also maybe you should just call me 812 664 2617
-
those cars came out as a half leaf set up.who did u get it from? and the guy that won the championship is a good friend of mine he could lead u in the right direction also have another friend just...
-
5 years ago i almost bought one but everyone in this area had one. so i went a differnt direction, they are really good cars race against one now he won the track championship with it.so if you can...
-
so Bill Hendrens what would you put on it callies magnum xls 36lbs crank and lunatti billet rods and j&e pistons. also small bert fly wheel if that makes any differnce
-
i have a new engine going together ati rattler is bad engine builder wants to replace it with fluid dampner? it has all light rotating ass. callies xls magnum crank and billet rods. what dampner...
-
would like a light connecting rod that will hold 750 horses and not break the bank looking to spend 800.00 to 1200.00 any info would be great .thanks also going on a callies magnum xls crank
All times are GMT -5. The time now is 04:09 PM.
|
|