Search:

If its custom pistons, forget it. Took them 6 tries and 4 months and they never got it right. I quit and asked for my money back.

They may be the best pistons in the world, but I am done with them

I ran E85 on 434 23 degree motor with a carb from Pro Flow systems. The carb was perfect right out of the box. All my E85 was out of the pump ranging from e82 to e88. if its over e85 i cut it with 93...

I am adding a rear mounted oil pump on a motor, on my little m block I just ran the line into the rear of the block, but I am using a stock 350 block. So i added a remote oil filter adapter and will...

no. the actual shaft in the pullbar

I noticed on my car that the pull bar shift is bent. It bent between the jam nuts. I have no idea why. Talk to chassis manufacturer and he gave me ideas but I can't find any thing out of place. ...

Location? Pictures? Contact info?

So knocked my trans seal out of my brinn two weeks in a row. The first time I just chalked it up to old seal, installed new seal and it did it again. So I am assuming the drive shaft yoke is hitting...

where are you located?

summit racing sells them

Are the Pits indoors?

That video on your home page was well done. BRAVO

I was wondering if the Brinn Pro Magnesium trans is legal in UMP/AMRA modifeds. Cant see any rule saying it is not, but with UMP you never know.

Again find a new engine builder

Those out of the box with titanium valves are 34cc. My SB2 heads were 36cc with 2.200 intakes. You will have to run a custom piston with a dish. Find a new engine builder

Anybody use a air tire changer to change there modified tires? The local shop says sidewalls are to soft.

If so while he kind do you use?

if your looking for a chassis, call Heavy Duty. He builds a fast car and his customer service is the BEST

Unless you race at PRP, then you have to pass tech before the race, during the race, after the race, on the trailer on your way home, while getting diesel for the truck. They even want to come to...

Tyvm I really appreciate it

is there a dust cap for the hybrid rotor I can buy at the local parts store?

The ones off my old rotors larger rotors are to small

After some research, the granada is 11 inch and the hybrid is 10 inch. I need to buy the hybrid bracket for that one side

I bought a new rotor for my pinto spindle, didn't really pay attention as the salesman said it was the one I needed, but it is roughly a inch smaller in diameter and the pads are only halfway on the...

Thanks, guys, I bought a new Bosch starter from NAPA and did the modifications. First time and it took about 20 minutes. It turns the motor over fine.

Says who at PRP?

I got two starters that need rebuilt, who does a good job

need some contact info

They in cases?