Search:

Type: Posts; User: lindsey97

Page 1 of 4 1 2 3 4

Search: Search took 1.24 seconds.

  1. Replies
    10
    Views
    3,606

    I run Advanced's digressive setup. I'm still a...

    I run Advanced's digressive setup. I'm still a little off on initial throttle up in the center of the corner but at exit it will hook up and never seems to quit pulling all the way down the...
  2. Replies
    47
    Views
    3,416

    The NeSmith series I would expect to be all GM as...

    The NeSmith series I would expect to be all GM as NeSmith is a GM dealer. Now some of the other crate series should look at other brand crate motors I think. But the crate thing in general, in my...
  3. Thread: Paducah?

    by lindsey97
    Replies
    14
    Views
    2,499

    I believe he will make it work. He is running...

    I believe he will make it work. He is running crates weekly, not sure of other classes. And he leased the track at Atwood for one year, never owe'd it. He has plans on running some late model shows....
  4. Replies
    7
    Views
    1,250

    Using a longer RF lower should tighten it more on...

    Using a longer RF lower should tighten it more on entry, same as the softer RF spring. With that model car I would think more LR bite, stiffer LR spring, softer LF spring, less rebound on 5th coil,...
  5. Replies
    4
    Views
    1,553

    34 1/2 and 36 are the measurements on my Pierce...

    34 1/2 and 36 are the measurements on my Pierce torque arm.
  6. Replies
    4
    Views
    1,553

    I can get you a measurement tonight.

    I can get you a measurement tonight.
  7. Replies
    39
    Views
    8,607

    I may be mistaken but I thought CJ, Moyer and...

    I may be mistaken but I thought CJ, Moyer and Larry Shaw were brother in laws??
  8. Replies
    20
    Views
    10,914

    Sounds like the same issue I have had with the...

    Sounds like the same issue I have had with the car I have been running last few years. Seems good when there's traction, rotates and drives off??? Couple of things to think about. What is your...
  9. Replies
    12
    Views
    3,288

    It is quickly becoming an interchange for the new...

    It is quickly becoming an interchange for the new I69 project. Think most of the pits were swallowed up by dirt work last time I was through there.
  10. Send you some tomorrow

    Send you some tomorrow
  11. Wilwood Wide 5 hubs, Bearings and Rotors

    4 ea. Wilwood wide 5 hubs, 2 front and 2 rear drive hubs with bearings

    4 ea. Wilwood 11.75 x 1.25 brake rotors with mounting bolts

    All items new in box never opened $800
  12. Replies
    0
    Views
    475

    2010 Larry Shaw by Al Purkey

    2010 Larry Shaw by Al Purkey
    Willwood brake pedals
    Master Cylinders and All lines installed with Electric RF shutoff
    Willwood front brake rotors and calipers
    OT, FP, WT and brake gauges...
  13. Replies
    4
    Views
    2,414

    Racinrocket1 check your pm's

    Racinrocket1 check your pm's
  14. Replies
    9
    Views
    2,233

    Crate flywheel or for open motor?

    Crate flywheel or for open motor?
  15. Replies
    136
    Views
    43,692

    I would imagine as soft as the late model tires...

    I would imagine as soft as the late model tires are, that water would act like a piece of lead inside the tire when you get up to speed. I know that fluid in a tractor tire will make it stiffer than...
  16. Replies
    17
    Views
    2,751

    No, Kinser makes a 14 inch filter for traditional...

    No, Kinser makes a 14 inch filter for traditional 4 barrel carbs. I have been running one for a couple of years. I haven't had any issues. I clean it every race and have never found dirt in the carb....
  17. Replies
    17
    Views
    2,751

    Sorry if I'm high jacking the thread. But..........

    Sorry if I'm high jacking the thread. But....... anyone have any dyno info or experience on the Kinser air filters?
  18. Thread: Lift bar

    by lindsey97
    Replies
    38
    Views
    10,373

    I know a guy that put one on his car about mid...

    I know a guy that put one on his car about mid season last year, he likes it. Haven't done a before and after stop watch, but it didn't seem to slow him down any.
  19. Replies
    2
    Views
    1,389

    Here is an option. I have always been pleased...

    Here is an option. I have always been pleased with the products I have bought from them. Seem like good people to deal with.
    ...
  20. Brian, Just sent you an email.

    Brian,

    Just sent you an email.
  21. Replies
    6
    Views
    887

    I sent you a PM, not sure it went through.

    I sent you a PM, not sure it went through.
  22. Replies
    9
    Views
    2,210

    One thing to keep in mind on the different...

    One thing to keep in mind on the different springs. There are different designs on birdcages and shock mounts and so on. My experience, older designs in birdcages don't favor soft spring/ heavy...
  23. Replies
    5
    Views
    1,922

    Mothers mag and aluminum polish with above ball...

    Mothers mag and aluminum polish with above ball or if you wait to long like I do. Use a buffer like you would buff a car with.
  24. Replies
    26
    Views
    5,873

    Probably better terms to describe it, but it...

    Probably better terms to describe it, but it eliminates the air coming around the nose and creating a vacuum effect in the left front wheel well area.
  25. Replies
    10
    Views
    2,614

    Are you driving the car in straight versus...

    Are you driving the car in straight versus throwing it in the corner? If so, raising the right lower bar and putting the LRF shock back on will help you turn the car on entry and through the middle...
Results 1 to 25 of 85
Page 1 of 4 1 2 3 4

All times are GMT -5. The time now is 05:42 PM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.