|
|
Search:
Type: Posts; User: 9WRACER
Search:
Search took 0.66 seconds.
-
Ttt---------------------------------------------------
-
Ttt------------------------------------------------
-
-
-
also comes with scales, front end gage, toe plates and spare new front and back bumpers
-
2008 smackdown, outpace 4 bars, tie rods and 1 piece lowers. Top a-frames are howe roller bearings with low friction ball joints. 12 nite old from new race 1 604, JDR e-85 carb, 5/8" HVH spacer,...
-
-
sold months ago, was a friends car, I'm on Integra IDA's
-
longer right lower a-frame, different rf upper, longer tie rod tubes, lf is the same, also ride heights are 3.5 inches. can get you the specs as I went to Mstersbilt seminar, just pm me and I will...
-
will sell for 1500.00, need it gone
-
SOLD motor had new rings and bearings last year, ran 18 nites. needs valve springs, sealed and a few heli coils on left side head for header bolts. 1800.00 Send PM to me and I will reply. older...
-
Transmission doesn't matter Just be sure if you have a brinn bellhousing use a brinn flywheel, or a bert bellhousing use a bert flywheel. Bert flywheel is a little smaller, will work in a brinn...
-
Bill, Craig had one down at allen automotive
-
What hole do you have your right lower bar in? That has alot of input on entry. Lower, tighter, higher frees it up
-
Crate late model team sellout. 08 smackdown car, 604 crate motor with Stealth lightweight E-85 carb, Genesis double adjustable gas shocks from Mastersbilt, new this year wirh ohlin 5th arm shock....
-
SOLD Crate late model team sellout. 08 smackdown car, 604 crate motor with Stealth lightweight E-85 carb, Genesis double adjustable gas shocks from Mastersbilt, new this year wirh ohlin 5th arm...
-
Make sure you have a good ground, to check use a set of jumper cables and run from the negative on the battery to the engine block, bad grounds can do that
-
Where are you located, I"m in Peoria
-
How long is the driveshaft?
-
I have 2 7" beadlocks 100 each
-
when we put the seal in I use the top part of the old cheap jack stand. The open round end fits the seal almost perfect and the flat stand piece I hit with a hammer to drive the seal in. The extra...
-
-
I have 2 7" bead locks, would sell for 120 a piece or trade them for good non beadlock 14" wide 5" offset wheels. These are 14" wide wheels.
-
I"ve bought several things also, allows in the shape he says, good prices and ships it quick!
-
races canceled for tonite, races still on for Sunday at regular time
All times are GMT -5. The time now is 07:51 PM.
|
|