Search:

I'm planning on using a 16 V battery with no alternator this year. was wondering what components need to be stepped down to 12 V so as not to cause damage. most concerned about right front brake...

Thanks guys I'll try and keep the oil where it belongs now

I'm trying to find the best product to use to clean oil from the underside of the car after a motor explosion. We used to use kerosene but I like to do something a little more eco-friendly.

We run a blue front rocket they have two sets of holes. Rocket recommends low and to the left for an all steel wet sump motor and high and to the right for an aluminum block Dry sump

I would replace the needle and seat in the carburetor nothing should be getting past them to have the fuel level rise it could be the o ring or the needle and seat itself. I've had both go bad and...

I was considering going from the 1.25to the .380 s also, would just spacing pads in the caliper be adequate?

We're on a Holley diaphragm pump I believe part number 12 dash 327 get the one for alcohol don't need a regulator runs about 8 to 9 psi at idle and doesn't give up at the end of the straight. I like...

Could be your car is tight on entry and your throwing it to make it turn once the tires arentt hooked up anymore they will continue to spin all the way through exit.

I talked to a guy at rocket about motor positioning they say any steel block should be moved to the left position on the motor plate mount I would also mount your weight high on the left side but...

Well we ran the car with 8 inches of dropped from the center line and it made no huge impact on Forward drive . Will go back to using left or right side drop for tight or loose handling. was worth a...

Simply put too much rear weight will cause a push too much forward will lack forward drive Although a tenth or so either way in percentage won't make too much difference

Okay thanks good info I know it's an adjustment I could only do in the shop during setup but I was hoping I could find more forward drive, like we're all looking for, by lowering both. they are both...

Wondering is there a specific height below the center line of the rear axle that the lower shock mounts should be set at? I imagine the lower you go the more motion you get and I guess even spacing...

The change in ratio is so small I think I'll just keep it cause I know its good instead of taking a chance at picking up another used one. the cost of a new one is better spent buying new tires in my...

Okay thanks that was what I was thinking I got a quote from Appleton gonna cost around 500 bucks Just hoping to save a little dough

Anyone have experience changing the ratio on in Appleton rack I'd like to go from a 3.4 to a 3.9 is it just a simple pinion change?

We're having an argument in our shop about the length of a dirt late model roof. There's a grey rule at our track about the length. I say shorter is better to let the air over down to the spoiler....