|
|
Search:
Type: Posts; User: ddsprint
Search:
Search took 0.36 seconds.
-
ya, thanks, adjusting buckets, made changes on the scale, 170 down to 90
-
what is the best way to adjust l/r wedge, pushing 130, looking for around 80, any help would be great, thanks
-
-
Set the axles to have very little play, although it holds axles in rearend well, so well that it took both the seals out that go around the axles, in the housing too far, so help me out on...
-
how many cars for the main? 24?
-
and in the end it is probably a bad ground, bad ignition switch, something stupid, as much as those cars buck around, It could easily happen
-
it is not so much as corner weight as it is weight %, mainly left side % in weight, rearend % weight and wedge from left to right, 40 to 80 lbs, don't worry about cross weight %
as far as %, it...
-
Looking for Input on this software, Any Information would be appreciated, thanks dan
-
Looking for some input on this software, has anyone used this software? thanks dan
-
Looked on Shaws website didn't find anything, so if anyone knows before I call let me know, thank you
-
-
looking for a chart for the cc to thousands of an inch, say take a 0.045 off 64 cc chamber heads, what would the cc be once this has occurred, have not found the table yet, any help would be...
-
Looking for the intake runner size, cc, and the rest of the info,
these heads have a number of rh350e
thanks
-
Where does one find the information and formulas for this process? Thanks
-
It would be the overlap of the valves, to tight, not allowing valves enough time to close and open,
-
what is your lsa at, you may have this very tight, and not allowing the valves to close in time before, next cycle
-
Does the Metric have a narrower front end than most? if so, what does one do to compensate if anything?
-
thanks for the feedback, Bob unfortunately it is not a pierce, apparently home built, with pierce geometry in front or close to, that is what I was told, otherwise I would call, it is somewhat a...
-
Spindles are gm metric, lower a frames are off a nova. Upper a frames are Rightfoot performance. Chassis really isn't a really a copy of anything. Front end geometry is close to a bob pierce car....
-
Ok, I'm waiting for the info on some of those questions you have, when I get the answers I will post info, thank you,
-
Just looking for some set up info on this type of Car, I have done a advanced search on here an found nothing, Any direction pointing would be greatly appreciated, thanks
-
It is wired up as listed from msd, although the coil blew up, So if anybody knows about this or it has happened to them, let me know, thanks
-
Thanks for all of the info, very helpful, thank you, dan
-
Well lets hear what a racers take on transmissions is, I'm going to be lookin for one soon, and unsure of which way I should go,
Any input would greatly appreciated, thank you,
-
Looking for some input on these carbs, the good brand or the not so good brands and why
If one can get a used one or is this is a bad idea,
I see there are quite a few brands out there,
...
All times are GMT -5. The time now is 12:54 PM.
|
|