Results 1 to 2 of 2
  1. #1

    Default Torque specs for Wilwood hubs?

    How much should you torque down a Wilwood wide 5 hub? Any help appreciated. Thanks!

  2. #2
    Join Date
    Jun 2007
    Posts
    3,123

    Default

    If you're talking about the spindle nut, you shouldn't. Just tighten to finger tight and make sure you don't have end-play (in and out). Then put your lock ring in place. Too much pre-load will damage the bearing.
    If you're talking about the drive flange bolts, it's 40-45 ft.lbs. then safety wire them properly.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

All times are GMT -5. The time now is 03:31 PM.


Powered by vBulletin® Version 4.2.0
Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.