engine midplate

[dfhotlm33c]

This is an '02 Boss..Any ideas what engine midplate I should use? Supposed to be a Mastersbilt copy. Using steel block, wet sump small block chevy. Thanks

[rubbinsracin]

Here is some contact info for Toma Johnson who builds the BOSS chasis:
toma@columbus.rr.com

[dfhotlm33c]

Thank you for the information. I have been attempting to email him for some time now, since I bought the car. To this point, he has not responded to any of my correspondence over a two month time period. I am certain he is very busy right now setting up cars and getting ready for race season! Sooo...if you could give me some info on the midplate that would be outstanding! Thanks!

[dfhotlm33c]

ttt...

anyone? Bueller? Bueller?

[rubbinsracin]

id go ahead and but a masterbuilt midplate from speedway, and as long as you never bolt it up and use it you can return it for the right one. just lay it up there and see if your mounts for the frame match up.

go online and pick up there catalog. the pictures in their catalog actually give some measurements if i remember correctly.

[JAMESGANGRACING]

the older wide cars used a 2 5/8 offset plate