Here's the rules for my class. Basically, I need a stock appearing clutch package. Been using the Ace products pressure plate, and unsure of the brand but a 6 puck disc. Think it was a Ram brand. What would everyone here suggest? I run the corvette/Zz28 flywheel, as it's relatively cheap, and the 10,000RPM one I had was very illegal.


A) A Stock OEM steel flywheel, or a replacement steel billet flywheel with OEM stock dimensions must be used.
B) Pressure plate must be stock OEM or a stock OEM replacement, with a minimum diameter of 10".
C) Clutch disc must be a steel stock OEM type or approved steel "paddle type", with a minimum diameter of 10"
The following are the minimum weights allowed for each part:
Flywheel (no bolts) –12.5 pounds.
Pressure plate & disc (no bolts)- 16 pounds.
The disc (no bolts) must maintain a minimum weight of 2.5 pounds and a maximum weight of 3.8 pounds after the combined weight has been determined.
E) Drilling or lightening of any part is not permitted.
F) Magnetic steel bolts only. Flat surface machining allowed only on the face of the flywheel, any cutting on the back side of the flywheel other than for balancing purposes is illegal.