How to remove bearing race from quick change cap

[engineer]

One of the bearings in the quick change cap on our Winters rearend came apart. I need to get the race out of the cap. After removing the bearing cover, there appears to be a metal retainer behind the race, but I don't see a way to get it out. What is the proper way to remove this race a put the new one in? Thanks for your help.

[C10]

you just tap it out, the retainer stays on the bearing until removed.

[Matt49]

Put it in the freezer first. May help.

[jedclampit]

Best bet is to replace the whole cover assembly with a bearing failure.

There is a set screw on the outside of the cover, recessed in a hole on some.(usually filled with silicone)
If you still have trouble getting it out, weld a bead around the inside of the race and it will shrink the od, usually falls right out with this., When it cools off.